Abstract:HTR-10GT is a closed Brayton cycle with two-stage compression and heat recuperation. Bypass control was adopted for rapid power regulation and safety protection. A bypass valve could be set between any two positions at different pressure levels, there would be in total 21 setting possibilities, whose regulating behaviors remained to be fully clarified. The dynamic characteristics of these settings were thus analyzed by implementing numerical simulation on the integrated system model. The reactor was modeled with point-kinetics and 1D thermal-hydraulics model; compressor performance calculation was based on digitization of the performance map and Reynolds number correlation; Flügel formula was chosen to calculate turbine performance. The system was modeled with Modelica, and the DASSL code was used to solve the Differential and Algebraic Equations. The results showed that only 6 choices among the 21 remained acceptable for engineering practice. The degree and rate on power output reduction, anti-surge effect and long-term thermal effects at reactor inlet and along recuperator’s metal wall were evaluated and compared among these choices to give out proposals. This research clarified the characteristics of bypass valves at different positions to give a reference on the final design of the control methods, and proposed a combination of valves for multi-valve cooperative regulation.

Research on dynamic mathematical model of top gas pressure in TRT system

Blast Furnace TRT Top Pressure Control Method Based on the Feedforward Mechanism Modeling

Identification And Control Of Blast Furnace Gas Top Pressure Recovery Turbine Unit

Design and simulation of TRT top gas pressure control system

System identification of TRT top gas pressure controlling process in BF charging operation

Research on the Mixed Logical Dynamical Model of the Hot Blast Stove

Modeling, simulation and experimental research on pressure tracking valve

Mathematical Modeling and Simulation of Extra-high Pressure Switching Air Supply

Simulation and Experimental Investigation on Pressure Dynamics of Pneumatic High-Speed On/off Valves

Simulation and Research of Pressure Regulator Valve in Boiler Feed-water Turbine Governing System

Finite element analysis and topology optimization of direct-drive compressor valve

Rotor Dynamics Analysis of TRT Based on ARMD

A simplified mathematical dynamic model of the HTR-10 high temperature gas-cooled reactor with control system design purposes

Investigation of the Compression and Expansion Process for Reciprocating Compressor

Lumped Parameter Dynamic Model of 10 MW High-Temperature Gas-Cooled Reactor

Study of Heat Loss Control for 3D Model in High Temperature and Pressure

Dynamic Mathematical Model of Helical Coils of Steam Generator of HTR-10

Analysis on Control Characteristic of Secondary Circuit Fluid Network of MHTGR Nuclear System

Investigation of Bypass Valve Positions on Performance of Closed Brayton Cycle

Research on Ways of Modeling of Micro Gas Turbines (part I):Analysis of Dynamic Characteristic

Simulation Study on the Condensing System of High-Temperature Reactor Demonstration Power Station HTR-PM 200 Based on Vpower