Abstract:Supercritical water injection is a promising technology for heavy oil thermal recovery. Predicting and regulating the thermophysical parameters of supercritical water at bottomhole are the prerequisite for achieving high re-covery efficiency. In this paper, a novel numerical model was proposed to simulate wellbore flow and heat transfer of supercritical water injection. A modified correlation of frictional coefficient was developed to calculate water flow resistance near its critical point, where its properties change abruptly. The unsteady heat loss to the formation was calculated directly by solving two-dimensional unsteady heat conduction equations. They were respectively coupled in momentum and energy balance equations using an iterative scheme. This model was proved to be accurate by two oilfield cases in which the relative errors of wellbore fluid pressure and temperature are less than 1%. Then parameters sensitivity analysis of the injection pressure, temperature, mass flux and the apparent heat conductivity of insulating tube was conducted. The results indicated that the tem-perature variation of wellbore fluid depended on both enthalpy drop (or heat loss) and Joule-Thomson effect. An abnormal phenomenon that the fluid temperature increased with wellbore depth near the critical and pseudo -critical points was found because of the sudden increase in high heat capacity and Joule-Thomson coefficient of water. Raising the bottomhole fluid temperature was the key to enhanced oil recovery by supercritical water injection. Low apparent heat conductivity of insulating tube contributed richly to raise bottomhole fluid tem-perature by enlarging thermal resistance and reducing wellbore heat loss. There existed an optimal mass flux for maximizing bottomhole temperature, because when the mass flux increased, the shortened resident time within wellbore and the decreased fluid pressure favored temperature increase and decrease respectively. Selecting an injection pressure near the critical or pseudo-critical point and raising the injection temperature would increase the bottomhole temperature and reduce relative fluid heat loss.

Study of Heat Loss Control for 3D Model in High Temperature and Pressure

The Study of Controlled Cooling Technology and Warping of X65 Heavy Pipeline Plate

Modeling and Simulation of Supercritical-Pressure Turbulent Heat Transfer of Aviation Kerosene with Detailed Pyrolytic Chemical Reactions

Analysis on Heat Transfer and Steam Injection in the Wellbore and Calculation on Heat Loss

Study on the Effect of Wellbore Heat Capacity on Steam Injection Well Heat Loss

A simulation research on thermal-pressure coupling loading of a 1:3.2 containment model

Numerical Simulation of Non-Isothermal Supercritical Water Flow in Ground Pipeline and Wellbore: an Interactive Sensitivity Analysis and Injection Parameters Optimization

Numerical Simulation of Flow and Heat Transfer Performance During Supercritical Water Injection in Vertical Wellbore: A Parameter Sensitivity Analysis

Three-dimensional modeling and loss-of-coolant accident analysis of high temperature gas cooled reactor

Simulation of Coupled Hydraulic–Thermal Characteristics for Energy-Saving Control of Steam Heating Pipeline

Temperature Field Research of High-pressure Heater Based on ANSYS

Mathematical Modeling of Heat Transfer and Pressure Drops in the Single- and Dual-Pipe Horizontal Wells

Numerical Simulation of High Pressure Gas Quenching Process

A Novel Prediction Model for Steam Temperature Field of Downhole Multi-Thermal Fluid Generator

INFLUENCE OF HEAT IN-LEAK, LONGITUDINAL CONDUCTION AND PROPERTY VARIATIONS ON THE PERFORMANCE OF CRYOGENIC PLATE-FIN HEAT EXCHANGERS

Integrative Model of Simulation System for Oil Filed Super-deep Well Environment

Mathematical Model of Heat Treatment and Its Computer Simulation

Steam Cavity Expansion Model for Steam Flooding in Deep Heavy Oil Reservoirs

A Comprehensive Heat Transfer Study Inside a Steam Turbine Valve: Experiment, Numerical Simulation, and Simplified Model

Analytical modeling on the geo-stress and casing damage prevention with the thermo-hydro-mechanical (THM) coupling of multi-field physics

Numerical model for steamtight analysis of high pressure casing of turbine