Abstract:In this paper a large-scale pulsed corona system is described in which pulse parameters such as pulse rise-time, peak voltage, pulse width and energy per pulse can be varied. The chemical efficiency of the system is determined by measuring ozone production. The temporal and spatial development of the discharge streamers is recorded using an ICCD camera with a shortest exposure time of 5 ns. The camera can be triggered at any moment starting from the time the voltage pulse arrives on the reactor, with an accuracy of less than 1 ns. Measurements were performed on an industrial size wire-plate reactor. The influence of pulse parameters like pulse voltage, DC bias voltage, rise-time and pulse repetition rate on plasma generation was monitored. It was observed that for higher peak voltages, an increase could be seen in the primary streamer velocity, the growth of the primary streamer diameter, the light intensity and the number of streamers per unit length of corona wire. No significant separate influence of DC bias voltage level was observed as long as the total reactor voltage (pulse + DC bias) remained constant and the DC bias voltage remained below the DC corona onset. For those situations in which the plasma appearance changed (e.g. different streamer velocity, diameter, intensity), a change in ozone production was also observed. The best chemical yields were obtained for low voltage (55 kV), low energetic pulses (0.4 J/pulse): 60 g (kWh)(-1). For high voltage (86 kV), high energetic pulses (2.3 J/pulse) the yield decreased to approximately 45 g (kWh)(-1), still a high value for ozone production in ambient air (RH 42%). The pulse repetition rate has no influence on plasma generation and on chemical efficiency up to 400 pulses per second.

Study on discharge characteristics of wire-plate pulse corona reactor

Investigation of pulse plasma reactor discharge characteristics

Evaluation of Pulse Voltage Generators

Comparison of Two-Type Corona Plasma Energization Techniques: Ultra-Short and DC/AC Power Sources

From Chemical Kinetics to Streamer Corona Reactor and Voltage Pulse Generator

Temporal development and chemical efficiency of positive streamers in a large scale wire-plate reactor as a function of voltage waveform parameters

Scale-up Experiment of Plasma Reactors with Different Electrode Structure

Bridging the Gap for Corona Plasma Applications : from Corona Characteristics, Chemical Kinetics to Pulsed Power Generator and Reactor

Energy efficiency optimization for H2S removal by dielectric barrier discharge plasma

A High-Voltage Pulse Generator for Corona Plasma Generation

Pulsed Corona Generation Using a Diode-Based Pulsed Power Generator

AC/DC Power Modulation for Corona Plasma Generation

Generation of Large-volume Plasma Under Low Air-pressure and Study of Its Electrical Characteristics

Optimizing Energy Efficiency for Industrial Application of Pulsed Corona Gas Cleaning Techniques

Study Of Geometry Structure On A Wire-Plate Pulsed Corona Discharge Reactor

Elements of Pulsed Corona Induced Non-Thermal Plasmas for Pollution Control and Sustainable Development

Corona induced non-thermal plasmas: Fundamental study and industrial applications

An Industrial Streamer Corona Plasma System for Gas Cleaning

Styrene removal using corona discharge combined with nanosecond pulse power supply

Streamer Corona Plasma for Fuel Gas Cleaning: Comparison of Energization Techniques

Streamer Corona Plasmas and the Chemical Effects on NO Removal