Abstract:Carbon nanotubes (CNTs) film has attracted extensive attention in the field of electronics, sensors, and other potential applications due to their excellent electrical conductivity. The conductivity of CNTs film is one of the most important aspects of engineering applications. This study investigates the conductivity of CNTs film with varying areal density, prepared using the floating catalyst chemical vapor deposition (FCCVD) method and densified by rolling. The square resistance of pre- and post-rolling films was measured to characterize the electrical properties. Experimental results indicate that square resistance decreases with increasing areal density and stabilizes eventually. A mathematical formula was derived to explain the relationship between areal density and square resistance, incorporating volume and areal density formulas. Experimental data curves of pre- and post-rolling films were fitted, yielding mathematical relations consistent with the derived formulas. The electrical conductivity of post-rolling CNTs film was superior to pre-rolling in experiment and calculation. The charge carrier transport mechanism in CNTs film was studied by analyzing its internal structure and electrical properties. Surface conductivity was over 1000 times higher than volume conductivity, attributed to the distribution of CNTs bundles in collection and thickness directions. Charge carrier transport capacity decreased with increasing layers in thickness direction due to contact resistance and large resistance at tube–tube junctions. Layers of CNTs near the current application surface significantly contribute to charge carrier transport at high areal density levels.

The study on controlling the density of Carbon nanotube film

Improvement of Purity and Field Emission Character of Carbon Nanotubes Film by Optimizing the Density of the Catalyst Solution

Study of Controlled Growth of Carbon Nanotubes in Microstructures at Low Temperature

J2240204 Evaluation of the Properties and Alignment of Carbon Nanotube Sheet Grown by CVD Method

Controlled Growth, Patterning and Placement of Carbon Nanotube Thin Films

Controlling the Density of CNTs by Different Underlayer Materials in PECVD Growth

Growth Process Conditions of Vertically Aligned Carbon Nanotubes Using Plasma Enhanced Chemical Vapor Deposition

Regulation on the thickness of aligned carbon nanotube arrays

Study on the electron cyclotron resonance plasma chemical vapor deposition of carbon nanotubes

Select Pathways to Carbon Nanotube Film Growth

Study on the law and mechanism of anisotropic conductivity of carbon nanotubes film prepared by floating catalytic chemical vapor deposition method

Controlled growth and supercapacitive behaviors of CVD carbon nanotube arrays

Modulating the Diameter of Carbon Nanotubes in Array Form Via Floating Catalyst Chemical Vapor Deposition

Effect of Carbon Nanotube Structural Parameters on Field Emission Properties

Controlled Growth Of Arrays Of Straight And Branched Carbon Nanotubes.

Mechanical Fabrication of Carbon Nanotube Films and Their Field-Emission Properties

Investigation on Site Density of Carbon Nanotube Forests

Field-emission Properties of Carbon Nanotubes Grown Using Cu–Cr Catalysts

Controlled Growth of Single‐Walled Carbon Nanotube Films by Iron‐assisted Floating Solid Catalyst Chemical Vapor Deposition

Microstructure Control of Fe Catalyst Films for the Growth of Multiwalled Carbon Nanotube Arrays

Study on the synthesis and field emission property of carbon nanotube film