Abstract:The objective of the current work is to the establish conventional mechanisms of grain refining, and the effect of the refiner-modifier interaction in Al-based alloys on the resultant grain refining obtained. The different castings were carried out in preheated metallic molds with solidification rates of around 0.15 °C/s and 7 °C/s. As the nucleation sites (Al 3 Ti) change in composition depending on the percentage of Si in the alloy, the term "poisoning" frequently used to explain the loss or weakening of the power of the refiner, is misused. Addition of L1 2 metals e.g., Zr and Sc would contribute to constitutional undercooling, restricting the coarsening of α-Al grains as well as act as suitable sites for heterogeneous nucleation. The use of transition or ultra pure (99.99) metals would increase the degree of undercooling as well as nucleation of new grains due to precipitation of the second phase leading to the formation of a heterogeneous grain distribution. Thus, grain refining of binary alloys - partially or fully, may not be produced only through constitutional undercooling. It is suggested that, the use of 0.18%Sc has more-or-less the same grain refining efficiency of 0.15%Ti added in the form of Al–Ti–B master alloy i.e., reduction in the grain size by about 85% and an increase in the alloy strength by about 30%. For a given solidification rate, there is a grain refining threshold beyond which no further refining can be achieved. Apparently grain refining mechanisms are independent of solidification rate, only the extent of refining.

Refinement of Intermetallic Compounds of Zn-2Ni Alloy

Refining Effect of Aluminum-Rare Earths on Structure of Zn-2%Ni Alloy

An experimental study of the effect of Ag, Cu, Li, Mg, Ni, Ti, Sc, Zr on grain refining in binary and multicomponent Al-based alloys

Influence of Co Contents and Super-Gravity Field on Refinement of In-Situ Ultra-Fined Fibers in Al-2.5Ni Eutectic Alloys

Refinement Mechanism of Microstructure of Undercooled Nickel Based Alloys

Microstructure of Al-Ti-B-RE Master Alloy and Its Mechanism of Refining Pure Aluminum

Research on Refinement of the High-Strength and Ductility Al-Si Alloy

Grain Refinement Mechanism at High Undercooling of Ni80Cu20 Alloy

Research on Grain Refinement of Sc and Zr Addition in an Al-Mg-Zn Alloy from Experiments and First-Principles Calculations

Refining Performance and Long Time Efficiency of Al-Ti-B-RE Master Alloy

Effectively Refining Al-10Si Alloy Via Al-Ti-Nb-B Refiner with Nb2O5

THE REFINING EFFECT OF Fe-Ti-N NUCLEATION ALLOY ON THE SOLIDIFIED STRUCTURE OF INDUSTRIAL PURE IRON

Intermetallic Growth and Interfacial Properties of the Grain Refiners in Al Alloys

Study on Grain Refining and Metamorphism of ZL111 Aluminium Alloys

Research of Grain Refining on Pure Al by Three Different Master Alloys

Study on Grain Refinement and Refining Mechanism of Al-Si-Mg Alloy

Refinement Mechanism of Trace Cr, Mn, Ti and Zr As Cast 7A55 Alloys

Micro-alloying effects of Ni on the microstructure and mechanical properties of an Al-Zn-Mg-Cu-Sc-Zr alloy

Study on Grain Refinement of A357 Alloy Using Al-5Ti-1B

Nucleation mechanism for grain refinement in A357 alloy by Al-Ti-B master alloys

Effect of Refining Processes on Inclusions and Mechanical Properties of Cast Al-2Li-2Cu-0.2Zr Alloy