Abstract:Abstract Saturated strata will degrade if residual pore water pressures in strata are less than the overburden pressures of strata under seismic loads. Because it is not better understood how to describe the p-y relationships of strata with residual pore water pressures so far, interactions of laterally loaded piles and degradation strata were researched in this paper. Saturated degradation strata were simulated by applying backpressures to strata that overburden pressures were acted on. Fifteen model tests were conducted to research effects of relative densities and residual pore water pressures on p-y relationships of saturated degradation sands. Results showed that lateral resistances of strata gradually decreased with the increase of residual pore water pressures and ultimate lateral resistances decreased by 80-90% for post-liquefaction strata. The method determining the ultimate lateral resistances was developed by defining the equivalent strength of saturated degradation strata and the reduced factor of residual pore water pressure of saturated degradation strata. Subgrade reaction modulus coefficients of saturated degradation strata were analyzed based on model test results, which showed that they also decreased with the increase of residual pore water pressures. Effects of pile-diameter on coefficients were further analyzed using the method of combined the 3D finite element and the Winkler foundation beam. Results showed that coefficients increased with increase of pile-diameter when the diameter was less than 0.4m and approached to constant results suggested in API Code when the diameter was greater than 0.4m. The formula determining coefficients of saturated degradation strata using the equivalent strength was developed. A method determining hyperbola p-y curves of saturated degradation strata was finally developed. Introduction It is an important content for offshore platform foundation design to evaluate the seismic resistance of pile foundations. The residual pore water pressure will exist in saturated sands under seismic loads. If the pressure approaches to the overburden pressure of the stratum, it will liquefy. If the pressure is less the pressure, the stratum will degraded due to residual pore water pressures [1], which means that the strength of strata with residual pore water pressures will decrease and lateral resistance acted on piles will also decrease. So it is very important for the design of ocean platform pile foundations to objectively evaluate lateral resistances of saturated strata with residual pore water pressures under seismic loads. The p-y model based on the nonlinear Winkler foundation beam theory is widely used to evaluate the pile-soil interaction under lateral loads. The hyperbola p-y curve can be used to describe the pile-soil interaction for saturated strata without residual pore water pressures [2-3]. But, it is not better understood how to determine p-y curves of saturated degradation strata so far. Therefore, p-y curves without considering the effect of residual pore water pressures are used to describe p-y relationships of saturated strata with residual pore water pressures for designing ocean platform pile foundations at present, which may be incorrect. In order to understand the p-y relationship of saturated sand strata with residual pore water pressures, Wang used the p-multiplier method to research variations of p-y curves during strata liquefaction by back analyzing shake table model test results [4-5]. To quantitatively analyzed interactions of piles and saturated degradation strata, Wang further developed a method simulating saturated degradation strata with different residual pore water pressures by applying the backpressure to saturated strata that the overburden pressure was acted on [6-7]. The method can be used to quantitatively research variations of p-y curves by model tests of pile-soil interaction under keeping constant residual pore water pressure in strata.

Research on lateral resistance of pile in saturated sand under shake loading

Large Deformation Analysis of Intermittent Pile Penetration into Dense Sand Incorporating a State Dependent Mohr–Coulomb Model

Lateral Bearing Performance of a Defective Pile-Supported Wharf with Batter Piles

Centrifuge Model Tests on Laterally Loaded Piles in Sand

Effect of Loading Rate on Lateral Pile-Soil Interaction in Sand Considering Partially Drained Condition

Performance of laterally loaded H-piles in sand

Centrifuge Modelling of Lateral Loading Behaviour of a “Semi-Rigid” Mono-pile in Soft Clay

Model tests on characteristics of ocean and offshore elevated piles with large lateral deflection

Model Tests on Elevated Piles Subjected to Lateral Static and Impact Loading

Centrifuge Modeling of Monotonic and Cyclic Lateral Behavior of Monopiles in Sand

Quantifying the Influence of Pile Diameter on the Load Transfer Curves of Laterally Loaded Monopile in Sand

Research on dynamic p-y curves in liquefied sand under cyclic loading conditions

Lateral Deformation Prediction Model of Pile Foundation in Liquefiable Site

A P-Y Curve Method for Horizontal Bearing Characteristics of Single Batter Pile in Sands

Field and Numerical Study of the Lateral Response of Rigid Piles in Sand

Ultimate Soil Resistance of the Laterally Loaded Pile in Uniform Sand

Bounding-surface-based p-y model for laterally loaded piles in undrained clay

P-y Model Describing Interactions of Piles and Saturated Degradation Sands

Influence of Pile Diameter and Aspect Ratio on the Lateral Response of Monopiles in Sand with Different Relative Densities

Behavior Analysis of Laterally Loaded Single Pile under Large Deflection

Pile Response to Liquefaction-Induced Lateral Spreading: A Shake-Table Investigation