Abstract:Large-diameter monopiles are the predominant foundation solution for supporting offshore wind turbines. They are conventionally designed using soil reaction curves developed for long slender piles used for supporting offshore oil and gas platforms (e.g., the API p-y model). However, due to the difference in the length/diameter ratio and the resulting soil mechanisms, the use of p-y curves alone can lead to significant under-prediction of the lateral stiffness and capacity of monopiles. To overcome the shortcoming, the authors have previously proposed a conceptual two-spring framework, i.e., the so-called 'p-y + M-R-theta(R)' model, to capture the monopile response in soft clay under lateral loading. The framework uses distributed p-y springs to consider the lateral soil resistance along the pile above the rotation point (RP) and a single moment-rotation (M-R-theta(R)) spring attached at the RP to capture the entire soil resistance below the RP, i.e., the distributed resistance along the pile, base shear and base moment at the pile tip. The proposed p-y and M-R-theta(R) springs were curve-fitted to the results of 3D numerical analyses. However, as the stress-strain response and the shear strength profile inevitably influence the p-y and M-R-theta(R) springs, the applicability of the empirical formulations to soil conditions other than those examined is uncertain. This study proposes an enhancement to the 'p-y + M-R-theta(R)' framework, in which the p-y and M-R-theta(R) springs are not tied to a specific soil and strength profile but fundamentally linked to the properties that can be measured directly in the site investigation and laboratory. This extension is achieved through analytical analyses and an extensive parametric numerical study. The predictive capabilities of the model are demonstrated by back-analyses of finite element analyses and centrifuge model tests. The proposed model provides practising engineers with a simple yet powerful approach to use site-specific soil reaction curves in the design of monopiles embedded in soft clay.

Bounding-surface-based p-y model for laterally loaded piles in undrained clay

Centrifuge Modelling of Lateral Loading Behaviour of a “Semi-Rigid” Mono-pile in Soft Clay

Lateral Bearing Performance of a Defective Pile-Supported Wharf with Batter Piles

Large Deformation Analysis of Intermittent Pile Penetration into Dense Sand Incorporating a State Dependent Mohr–Coulomb Model

A Multi-Axial Bounding Surface P-Y Model with Application in Analyzing Pile Responses under Multi-Directional Lateral Cycling

A Bounding-Surface-based Cyclic "P-Y Plus M-θ" Model for Unified Description of Laterally Loaded Piles with Different Failure Modes in Clay

Centrifuge Model Tests on Laterally Loaded Piles in Sand

Lateral Cyclic Pile–soil Interaction Studies on a Rigid Model Monopile

Field Tests of Offshore Driven Piles Subjected to Lateral Monotonic and Cyclic Loads in Soft Clay

Effect of Loading Rate on Lateral Pile-Soil Interaction in Sand Considering Partially Drained Condition

Centrifuge Modelling of Lateral Cyclic Behaviour of a Tetrapod Piled Jacket in Soft Clay

Model tests on characteristics of ocean and offshore elevated piles with large lateral deflection

A Numerical Study on the Lateral Loading Behaviour of Offshore Tetrapod Piled Jacket Foundations in Clay

Model Tests on Elevated Piles Subjected to Lateral Static and Impact Loading

Centrifuge Modelling for Seismic Response of Single Pile for Wind Turbine Subjected to Lateral Load

A bounding-surface based cyclic ‘p-y+M-θ’ model for unified description of laterally loaded piles with different failure modes in clay

Development of cyclic p–y curves for laterally loaded pile based on T-bar penetration tests in clay

Cyclic Lateral Response and Failure Mechanisms of Semi-Rigid Pile in Soft Clay: Centrifuge Tests and Numerical Modelling

Lateral Deformation Prediction Model of Pile Foundation in Liquefiable Site

Site-specific soil reaction model for monopiles in soft clay based on laboratory element stress-strain curves

Dynamic Response of Offshore Open-Ended Pile under Lateral Cyclic Loadings