Abstract:Compared with traditional partial discharge(PD) detections, optical PD detection has significant advantages in anti-interference, intrinsic characterization and sensitivity in the particle discharge detection of Gas Insulted Switcher(GIS). Optical PD positioning is an efficient and economical positioning method which has a high practical value. In this paper, a new optical sensor array positioning system, consisted of three Silicon photomultipliers(SiPM) in different planes, is designed to locate the PD source in a distance. As the distance between SiPM and PD source increased, the PD source can be regard as a point light source, and the light illuminate to the SiPM is considered to be parallel light. In this circumstance, the radiant flux illuminating to the SiPM is proportional to the cosine of the angle between SiPM plane normal vector and the parallel light. Thus, we can use these characteristics to find the PD source. First, we verified that the quantitative relationship between SiPM output and the cosine of the angle between SiPM plane normal vector and the parallel light intensity. Second, we established nonlinear equations to find the approximately position of the PD source. The calculation of the equations show that there would be a 1cm acceptable positioning deviation with a 30cm distance between SiPM and PD source. The deviation is caused by reflection, measurement error, and some non-linear factor. Owing to its distinctive positioning mechanism, the optical PD positioning by SiPM has the advantages in sensitivity and low cost comparing with traditional positioning technology On the other hand, the problem of accuracy practical application of the system still need more research effort.

Analysis of the influence of photo detector integrated circuit position error on differential phase detection signal

Influence of Optical Pick-up Assembly Error on Tracking Signal

Research on the 1D PSD

Analysis of the Effects of Disk Tilt on the Differential-Phase-Detection Signal in A High-Density Dvd Read-Only Disk Driver

Novel DPD signal detection method for read-only high density optical disks

Analysis of Cross Talk Between Radial Tilt Error and Tracking Error Signal of A High-Density Digital Disk

Analysis of the Differential Phase Detection Signal in Multi-level Run-Length Limited Read-Only Disk Driver

Analysis of Crosstalk Between Radial Tilt Error and Tracking Error Signal of Optical Disc System

A New Design of CMOS PDIC for DVD Optical Pickup System

Phase Error Analysis and Reduction in Phase Measuring Deflectometry

Detection method of EF phase difference of DVD optical pickup

Analysis of the focus error characteristic in high density optical disk driver

Measurement Accuracy Improvement With Pzt Scanning For Detection Of Dpc In Hi-Bi Fibers

Error Analysis of the plate beamsplitter in near optical coaxial phase measurement deflectometry

A New Optical Method of Partial Discharge Distant Positioning in GIS

Embedded displacement measuring device based on error separating technique of multi-circle overlapping three-probe method

Analysis of Differential Phase Detection Signal of a Novel Multi-Level Read-Only Disc

New Differential Phase Detection Method for Signal Waveform Modulation Multi-Level Discs

Validity Analysis of Scalar Diffraction Theory in Optical System of Optical Disk

Correction of the Relationship Between Opticalelectrical Signal and Charge Quantity in Partial Discharge Combined Detection

Film-thickness Error Analysis of Optical Disk Systems