Abstract:Diamond-Like Carbon (DLC) is thought to be a potential material in solving heat dissipation problems in light emitting diode module packages. It is of vital importance in evaluating the thermal conductivity of DLC film deposited on a silicon substrate. In this paper, the molecular dynamics method is used to simulate the formation of a DLC film by the deposition of carbon atoms on a isilicon substrate. Tersoff potential is adopted to reproduce the structures and densities of silicon, carbon, and SiC. A silicon substrate consisting of 544 atoms is located at the bottom of the simulation domain. The substrate is kept at a temperature of 600 K through a Noose-Hover thermostat. Carbon atoms are injected into the substrate individually every 0.5 ps at an energy of 1 eV. After a 7.5 ns deposition process, a 4 nm amorphous film containing 15000 carbon atoms is formed. Injected carbon atoms and substrate silicon atoms are intermixed at the bottom layer of the deposited film while the rest of the film contains only carbon atoms. The density of the film decreases slightly with the increase of the height of the deposited film and the average density is 2.8 g/cm3. Analysis of the coordination number shows that the sp3 fraction of carbon atoms in the film also decreases with the increase of the height of the deposited film, with a maximum value of 22%. It might be caused by the continuous impacts of the subsequently injected carbon atoms on the previously formed DLC film. The thermal conductivities of the DLC film in the planar and normal directions are calculated by the Green-Kubo method. The thermal conductivity of pure diamond film is also calculated for comparison. The results show that the planar thermal conductivity of the deposited DLC film is approximately half of that of the pure diamond film with the same size. It is higher than the normal thermal conductivity of the deposited film. The thermal conductivities of the DLC film in both planar and normal directions increase with the increase of film density and sp3 fraction in the DLC film. The results indicate that the local tetrahedral structure of sp3 carbon atoms contributes to the improvement of thermal conductivity in the DLC film.

Research on application of DLC films to solving MEMS stick

Diamond and diamond-like carbon MEMS

Study on the design of anti-sticking structures in MEMS under different forces

Diamond-like Carbon Film on 20 CrNiMo Steel Prepared by Hollow-Cathode Glow Discharge

Interface architecture for superthick carbon-based films toward low internal stress and ultrahigh load-bearing capacity

Micro-structural, electrical, and tribological properties of SiC/DLC composite coating grown by PLD on steel

Laser micromachining of sputtered DLC films

Capillary Adhesion Between the Micro-Cantilever and the Substrate

Regulating the fretting behavior of diamond-like carbon films by changing the composition and structure

Probing the friction mechanism of diamond-like carbon films in aqueous environments based on molecular dynamics simulations

Dep Osition and Thermal Conductivity of Diamond-Like Carb on Film on a Silicon Substrate

Afm/Ffm Study Of Micro/Nano-Tribological Properties Of Diamond-Like Carbon Film

Microcontact printing fabrication of diamond MEMS cantilevers on silicon substrate

Fretting behaviors of self-mated diamond-like carbon films: The evolution of fretting regime and transfer film

A coarse-grained study on mechanical behaviors of diamond-like carbon based on machine learning

Influence of SiC intermediate layer on adhesion property of F-DLC film

Molecular dynamics simulation of hybrid structure and mechanical properties of DLC/Ni-DLC thin films

Structural Characters and Tribological Properties of Diamondlike Carbon Films

Excellent Adhered Thick Diamond-Like Carbon Coatings by Optimizing Hetero-Interfaces with Sequential Highly Energetic Cr and C Ion Treatment

Evaluation of Diamond-Like Carbon Films Electrodeposited on an Al Substrate from the Liquid Phase with Pulse-Modulated Power