Abstract:Aiming at the frequent issue of pit-shaped surface defects in S-bearing and Al-killed steel products and the related poor castability due to submerged entry nozzle (SEN) clogging, the melting and casting process of a popular auto steel Cf53 has been studied based on in-situ investigation and experimental analysis. To clarify the generation of the pit-shaped defects, the local surface chemistry, evolution of steel inclusions throughout the melting process, SEN clogging substances, and the internal relationship among them were systematically analyzed. The results show that this type of defect in the Cf53 rolled products is caused by the large-sized composite inclusions rich in CaS, which originate from the molten steel during the refining process, gradually accumulate on the inner wall of the SEN during casting, and finally lead to SEN clogging. The loose structure of clogging inclusions makes them prone to fall off into the mold and get trapped by solidifying steel shell. The formation mechanism of the inclusions was studied through FactSage software calculation. The results show that the increase in total sulfur and total calcium content, and the decrease in total oxygen content and temperature in steel will lead to CaS inclusion formation, which agrees reasonably well with experimental results. An optimized refining process to reduce calcium addition into molten steel is proposed accordingly, which achieves a remarkably alleviation in casting SEN clogging and an elimination of the pit-shaped defects on the final rolled products as well.

Failure Analysis of M300 Steel for Nozzle Body in Zinc Alloy Die Casting Machine

The Analysis of Influing Factor of the Failure of Nozzle Body in Zinc-alloy Die Casting

Failure Analysis of Nozzle Body for Zinc-alloy Die Casting and Measures of Improving its Service Life

Investigation on Surface Defects Produced in Pretreatment of Die-casting AM60B Magnesium Alloy

Failure Behavior of High Pressure Die Casting AZ91D Magnesium Alloy

High-Temperature Mechanical Behavior of an As-Extruded Al-5Zn-2Mg-0.3Cu (in wt.%) Alloy

Formation mechanism and control of a kind of pit-shaped defect in Cf53 rolled products

The Microstructure and Mechanical and Corrosion Behaviors of Thermally Aged Z3CN20-09M Cast Stainless Steel for Primary Coolant Pipes of Nuclear Power Plants

Crack analysis of Cr-Mo-V-Si medium-carbon alloy steel in casting die

Metallographic Evaluation of Increased Susceptibility to Intermediate Embrittlement of Engine Valve Forgings Made of NCF 3015 High Nickel and Chromium Steel

On the Tensile Failure Induced by Defect Band in High Pressure Die Casting of AM60B Magnesium Alloy

Experimental Investigation of Hot Forming of Zn‐Coated Hot‐Stamping Steel

Failure analysis and numerical drive structure optimization design of Cr12Mo1V1 electrical connection die

Fracture failure analysis of the teeth of conjunction gear made of 20MnCr5S steel

High-cycle fatigue failure analysis of cast Al-Si alloy engine cylinder head

Failure analysis of 2205 duplex stainless steel connecting pipe for composite plate pressure vessel in a high pressure gas field

Influence of pore defects on the mechanical property and corrosion behavior of SLM 18Ni300 maraging steel

Failure Behavior of Ultra-high Cycle Fatigue of a 2 000 MPa Grade High Strength Steel

Failure Analysis of the Cavity at the Advanced Mirror Plastic Mold Surface

Effect of SO2 and NH3 on the Corrosion Failure of Zn-Al-Mg Coatings

The Main Failure Modes of Hot-Work Die Steel and the Development Status of Traditional Strengthening Methods and Nano-Strengthening Technology