Abstract:The micro-electro-mechanical system (MEMS) resonator developed based on surface processing technology usually changes the section shape either due to excessive etching or insufficient etching. In this paper, a section parameter is proposed to describe the microbeam changes in the upper and lower sections. The effect of section change on the mechanical properties is studied analytically and verified through numerical and finite element solutions. A doubly-clamped microbeam-based resonator, which is actuated by an electrode on one side, is investigated. The higher-order model is derived without neglecting the effects of neutral plane stretching and electrostatic nonlinearity. Further, the Galerkin method and Newton⁻Cotes method are used to reduce the complexity and order of the derived model. First of all, the influence of microbeam shape and gap variation on the static pull-in are studied. Then, the dynamic analysis of the system is investigated. The method of multiple scales (MMS) is applied to determine the response of the system for small amplitude vibrations. The relationship between the microbeam shape and the frequency response is discussed. Results show that the change of section and gap distance can make the vibration soften, harden, and so on. Furthermore, when the amplitude of vibration is large, the frequency response softening effect is weakened by the MMS. If the nonlinearity shows hardening-type behavior at the beginning, with the increase of the amplitude, the frequency response will shift from hardening to softening behavior. The large amplitude in-well motions are studied to investigate the transitions between hardening and softening behaviors. Finally, the finite element analysis using COMSOL software (COMSOL Inc., Stockholm, Sweden) is carried out to verify the theoretical results, and the two results are very close to each other in the stable region.

Effects Of Residual Stress And High Load On The Dynamic Characteristics Of Mems Devices

Thermal Stress Analysis of MEMS Accelerometer Based on Finite Element Method

Research On High-Frequency Vibratory Stress Relief For Small Assembly

Effects of Structural Dimension Variation on the Vibration of MEMS Ring-Based Gyroscopes

Investigation of a Complete Squeeze-Film Damping Model for MEMS Devices

Thermal stress of MOEMS Accelerometers Based on Grating Interferometric cavity

Static and Dynamic Mechanical Behaviors of Electrostatic MEMS Resonator with Surface Processing Error

Effects of Residual Stress on Static and Dynamic Characteristics of an Electrostatically Actuated Nanobeam

RESIDUAL STRESSES IN MICRO-ELECTRO-MECHANICAL SYSTEMS

Overview of residual stress in MEMS structures: Its origin, measurement, and control

A new in situ residual stress measurement method for a MEMS thin fixed-fixed beam structure

Recent Efforts in Modelling Combined Rate, Size and Thermal Effects on Single Crystal Strength

Residual stress measurement method in MEMS microbeams using frequency shift data

Oscillation Behavior of Two Mems Structures

Suspended Gate Field Effect Transistor Type Microelectromechanical Systems Resonators Modelling with Micro-Raman Spectroscopy Measured Residual Stress

Variation of MEMS Thin Film Device Parameters under the Influence of Thermal Stresses

Characterization of Residual Stress in SOI Wafers by Using MEMS Cantilever Beams

Evaluation of Die Stress in MEMS Packaging: Experimental and Theoretical Approaches

Radiation effects on mechanical characteristics of MEMS

Evaluation of Residual Stress in MEMS Micromirror Die Surface Mounting Process and Shock Destructive Reliability Test

A Method to Evaluate the Influence of Different Substrate on Stress Mismatch Induced Deformation in MEMS Accelerometer