Abstract:Electrical discharge machining (EDM) is frequently employed in micropore machining of difficult-to-cut materials as a result of the contactless characteristics. However, debris produced by electrode discharge ablation of the workpiece tends to accumulate at the bottom of the hole and is difficult to discharge, resulting in abnormal discharge, which reduces processing efficiency and increases electrode loss. These issues can be resolved with the introduction of ultrasonic-assisted technology, but since it is difficult to obviously observe micro phenomena like bubble rupture, fluid movement, and debris movement, there has been little real-situation study on fluid environments. In this study, first, mathematical models of the improvement of ultrasonic-assisted discharge energy and erosion efficiency were developed. Then, the ultrasound-assisted electrical discharge machining (UEDM) process was simulated on the basis of gas–liquid-solid three-phase fluid coupling analysis to investigate the influence law of the ultrasonic cavitation effect and pumping effect on fluid movement and debris movement. Then, the comparative test of EDM and UEDM in machining titanium alloy plate was carried out to explore the impact of ultrasonic-assisted technology on the level of single process parameters, taking the processing time, electrode loss, and hole taper as indicators, respectively. Finally, multi-objective particle swarm optimization (MOPSO) was used to obtain the optimal parameter group of EDM and UEDM, and this parameter group was used for drilling test to examine the effects of ultrasonic-assisted technology on the process parameter level. According to the research, the fluid stability is destroyed by the effects of ultrasonic cavitation and pumping, which also increase the local fluid speed by a hundred times and encourage the discharge of debris, thereby reducing the processing time, lowering electrode loss, lowering hole taper, and improving the surface quality of micropores.

Research On Edm Active Oscillation Pulses Based On Discharge Mechanism

Experimental Research on Pulse Generator for EDM of Non-Conductive Ceramics

Study on characteristics of EDM using pulse power supply with active high-frequency oscillation

Pulsed Power Supply Superposed With Radio Frequency Oscillating Wave for the Improvement of Micro-Electrical Discharge Machining Process

Pulse Dynamic Regulation of Electrochemical Discharge Milling by Utilizing the Slotted Tube Electrode

Pulsed Power Supply Superposed with RF Oscillating Wave for the Improvement of Micro EDM Process

A discharge plasma regulation method with spike current for electrical discharge machining

Research on machining Technology of Electrospark-electrochemical Hybrid Energy Field with tungsten hole

High-speed Near Dry Electrical Discharge Machining

Study of Alternating Current Flow in Micro-Edm Through Real-Time Pulse Counting

Progress in modeling of electrical discharge machining process

Study on the Characteristics of Plasma Channel Based on Multi-Spark Pulse Discharge Machining Effect

Advanced Electric Discharge Machining of Stainless Steels: Assessment of the State of the Art, Gaps and Future Prospect

A review of the current understanding and technology of powder mixed electrical discharge machining (PMEDM)

Improvement of ultrasonic cavitation and pumping effect in microhole EDM

An EDM pulse power generator and its feasible experiments for drilling film cooling holes

Comparative Study of Ultrasonic Vibration-Assisted Die-Sinking Micro-Electrical Discharge Machining on Polycrystalline Diamond and Titanium

Analysis and control of electrical discharge machining (EDM) process

EDM Electrode Design and Analysis to Enhance Process Performance

Machining Mechanisms and Characteristics of Moving Electric Arcs in High-Speed EDM Milling

A High Energy Density Pulsed Power Supply for Micro EDM of High Aspect Ratio Holes