Abstract:ZL702A/SUS304 bimetallic castings were prepared by compound casting with different surface pretreatments , in terms of hot-dip aluminizing method and surface modifier + hot-dip aluminizing method. The bimetal interface prepared with no surface modifier was consisted of a tongue-like AlFeSi compound layer and an oxidation layer containing numerous micro-voids, accompanied with aluminum oxide curves near the interface which were overlapped with eutectic Si along grain boundaries in ZL702A substrate. In the case of surface modifier + hot-dip aluminizing, the incompact oxidation layer was almost disappeared at the interface, with no other observable microstructural difference relative to its counterpart. In consequence, the additional surface modifier greatly increased the integrity of the bimetal interface and leaded to a significant improvement of shear strength to ∼77.9 MPa, in comparison to its counterpart with no surface modifier of ∼21.7 MPa. Fracture during shear test in the bimetal with no surface modifier was dominantly occurred along the fragile oxidation layer. While in the bimetal with surface modifier, fracture was mainly occurred in the more compact and ductile ZL702A substrate, accounting for the increase of its shear strength. This work provides fresh ideas for tailoring the interfacial microstructure and improving the bonding properties of Al/steel bimetals by compound casting.

Effects of Modification on Surface Tension of ZL102 Al-Si Alloy

The Effect of Solution Treatment on the Si Particles’ Morphology Evolution and the Thermal Conductivity and Tensile Properties of Sb-Modified Al-8Si-0.6Mg Alloys

Effects of Refinement and Modification on Melt Structure of Hypoeutectic Al-Si Alloy

New Method and Experimental Study for Fast Evaluating Filling Mould Ability of Al-Si Alloy by Surface Tension

Thermodynamics of effect of modification on microstructure of Al-Si alloy melt

Modification mechanism and tensile property of Al-9Si-0.4Mg-0.1Cu alloy

Surface tension and viscosity of Zr–Ti–Cu liquid alloys

Mechanical Performances of Al-Si-Mg Alloy with Dilute Sc and Sr Elements

Surface tension measurement of Ti–Zr and Ti–Hf alloys at high-temperature by the pendant drop method

Influences of different Zr/Sc ratios on microstructure and mechanical properties of Al-2Si alloy

Evolution of interfacial structure and fracture behavior in ZL702A/SUS304 compound castings with different surface treatments

Effect of in-situ Al2O3 on tensile strength and ductility of AlSi10Mg alloy fabricated by selective laser melting

Yield strength prediction of rolled Al−(1.44−12.40)Si−0.7Mg alloy sheets under T4 condition

Effect of Si content on interfacial reaction and properties between solid steel and liquid aluminum

Quantified effect of quench rate on the microstructures and mechanical properties of an Al–Mg–Si alloy

Effect on Wetting Properties of the Al-Ti System by the Addition of Different Alloying Elements

Investigation on surface tension of CaF2–CaO–SiO2 (–MgO–Al2O3) melts

Simulation on microstructure evolution of Al−Si alloy under effect of natural convection during solidification

Experiment and Numerical Simulation of Microstructure of ZL114A Alloy in Low Pressure Casting

EFFECTS OF THE ADDITION OF Ti OR Al ON THE WETTING BEHAVIORS AND INTERFACIAL CHARACTERISTICS OF Zr 50 Cu 50 BULK METALLIC GLASS/W SUBSTRATE

Effects of Zr and Sr on microstructure and mechanical properties of cast Al–Si–Cu–Ni–Mg alloy