Abstract:In this study, both the distribution of residual stress and welding deformation in a double-pass T-joint made of low-alloy ultra-high strength (UHS) quenched steel have been investigated experimentally and numerically. Using Abaqus software, the primary aim of this study is to develop an advanced computational approach incorporating a highly precise material model that accounts for solid-state phase transformation (SSPT) in the heat-affected zone (HAZ) and softening effect (SE) in the subcritical heat-affected zone (SCHAZ) to simulate residual stress and welding deformation in the double-pass T-joint. The predictions of welding thermal cycles, residual stress distribution, and welding deformation made by the finite element model have been validated against corresponding experimental results. When both SSPT and SE were considered in the finite element model, the predictions closely aligned with the experimental measurements. The experimental findings reveal that the maximum degree of softening in a T-joint subjected to double thermal cycles is more pronounced than in a T-joint subjected to a single thermal cycle. The simulation results indicate that SSPT significantly impacts both the magnitude and distribution of residual stress in the HAZ of the T-joint, while SE also can reduce the magnitude of longitudinal residual stress to a certain extent especially in SCHAZ. Furthermore, the simulation results suggest that SSPT moderately affects the distribution of longitudinal plastic strain in the double-pass T-joint, with minimal influence on angular distortion and transverse shrinkage. Additionally, the simulation results indicate that the SE has a limited impact on the welding deformation of the T-joint.

Numerical Simulation of Welding Residual Stress of Tube-to-tubesheet Joint in Heat Exchangers

Effect of Tube Arrangement on the Welding of the Tube-to-Tubesheet Joint of Shell-and-Tube Heat Exchangers Using the Finite Element Method

Prediction of Residual Stress Distributions in Welded Sections of P92 Pipes with Small Diameter and Thick Wall Based on 3D Finite Element Simulation

Numerical simulation of thermal and residual stress fields induced by lined pipe welding

Numerical Simulation of Tube-Plate Welding Structure with T-Shaped Sections

Welding Numerical Simulation Analysis of AP 1000 Insert Plate and Penetration Sleeves Based on ABAQUS

Finite element simulation of welding process and real-time monitoring assessment

FE analysis of residual stress and welding deformation of a low-alloy UHS quenched steel fillet joint

Numerical Simulation of Residual Stresses in Multipass Gas Metal Arc-Welded Joints of Thick Aluminum Alloy Plates

Electromagnetic Ultrasonic Measurement for Welding Residual Stress Detection - Comparison Between Experiment with Numerical Simulation

Effect of welding residual stress on the performance of CFST tubular joints

Numerical Simulation of Fluid-Elastic Instability in Heat Exchanger Tube Bundles

Numerical Investigation on Stress Distribution and Evolution in 9cr/2.25cr Dissimilar Welded Rotor Undergoing Welding and Heat Treatment

Effect of Welding Sequence and the Transverse Geometry of the Weld Overlay on the Distribution of Residual Stress in the Weld Overlay Repair of T23 Tubes

Numerical simulation and analysis of welding of drive axle housing and axle tube

Numerical Study on Welding Residual Stress Distribution of Corrugated Steel Webs

Numerical simulation of residual stress in post internal-welding process of bimetal composite pipe and optimization of welding sequence

3D finite element analysis and optimization of welding residual stress in the girth joints of X80 steel pipeline

Numerical Analysis of Welding in Fillet Weld for High-Pressure Pipeline In-Service

Numerical Simulations of Welding Residual Stresses in VPTIG-welded Joints of the 2219 Aluminum Alloy

Numerical Simulation of Temperature Evolution, Solid Phase Transformation, and Residual Stress Distribution during Multi-Pass Welding Process of EH36 Marine Steel