Abstract:There is a vast amount of globally underutilized low-grade mine tailings and leach residues, including those from primary processing of gold. In this research, the target is to recover the remaining gold (10.9 g/t) from weathered refractory iron-rich residue that had previously been subject to autoclave oxidation, subsequent cyanidation in a conventional carbon-in-leach (CIL) circuit as well as storage at tailings area. Chloride leaching has been considered as one of the most promising cyanide-free gold leaching methods and it has shown positive outcomes in treating primary gold ores, concentrates, and flotation tailings. Therefore, in the current study, the iron-rich residue investigated was subjected to chloride leaching combined with simultaneous carbon adsorption. The investigated parameters included leaching time (2–8 h), chloride concentration ( [Cl − ] = 0.2–5 M), type and concentration of oxidant ( [Cu 2+ ]/[Fe 3+ ] = 0.1–1 M), as well as type and concentration of activated carbon (14–25 g/L), whereas S/L ratio (100 g/L), acidity ( pH = 1), and temperature (90 °C) were kept constant. Leaching results indicate that up to 40% of the remaining gold could still be recovered from the investigated residue with optimized chloride leaching. According to the results, the most important parameter for gold recovery was the leaching time. Moreover, of the studied oxidants, cupric ions were shown to contribute more to gold recovery when compared to ferric ions (35% vs. 24% at [Cu 2+ ]/[Fe 3+ ] = 0.1 M). Nevertheless, an increase of cupric concentration from 0.1 M (low-concentrated) to 0.5 M, resulted in only a slight increase in gold recovery (from 36% to 40%), whereas no further improvement in gold recovery was achieved with a 1 M cupric concentration. Two studied activated carbon products showed equal effectiveness in gold adsorption. In-situ carbon adsorption was shown to occur effectively in chloride media, as all dissolved gold could be detected in the activated carbon, and the concentration of remaining gold in the pregnant leach solution was minimal (< 0.02 mg/L). These findings indicate that low-concentrated chloride leaching of leach residues from industrial gold processes can allow an enhanced recovery of gold from previously mined and treated raw materials.

Gold extraction from a low grade ore using the system of metal-ammonium-chloride-ammonia

Facile and Novel Method for the Recovery of Gold from a Calcined Concentrate Via Copper–ammonia -Thiourea System and Activated Carbon

Reagent Elution Combined with Positive Pressure Filtration: A Zero-Discharge Method for Cyanide Tailings Remediation

Efficient recovery of gold using Macroporous Metal-Organic framework prepared by the 'MOF in MOF' method

Efficient and stable leaching of gold in a novel ethydiaminedhephen acetic-thiosulfate system

Gold extraction from Carlin-type concentrate by a novel environmentally friendly lixiviant

Mechanism of synergistic pretreatment with eco-friendly CaO and Na 2 CO 3 to enhance gold leaching efficiency from fine-disseminated gold ores

Synergistical Thiourea and Thiosulfate Leaching Gold from a Gold Concentrate Calcine with Copper-Ammonia Catalysis

Extraction of Gold from the Leachate of Copper Anode Slime by Quaternary Ammonium Rice Husk Lignin

STRIPPING OF GOLD FROM QUATERNARY AMINE EXTRACTION SYSTEMS

Progress in Gold Solvent Extraction

Renewable ammonium chloride-induced calcium leaching of gold and copper tailings and selective preparation of vaterite CaCO 3 by CO 2 mineralization

Enhanced Hydrometallurgical Pretreatment of Micro-disseminated Gold Ore

The Extraction Of Low-Concentrations Of Gold(I) With Au-198 As A Radiotracer

Sustainable and effective gold(I) separation from aurocyanides wastewater and its mechanism using guanidinium ionic liquids

Highly Efficient Recovery of Au(I) from Gold Leaching Solution Using Sodium Dimethyldithiocarbamate

Gold recovery from cyanidation residue by chloride leaching and carbon adsorption – Preliminary results from CICL process

Solvent Extraction Of Gold From Alkaline Cyanide Solution By Primary Amine N1923

Extraction of gold(III) from hydrochloric acid solutions by CTAB/n-heptane/iso-amyl alcohol/Na2SO3 microemulsion

A green and efficient utilization of refractory cyanide tailings containing inclusion gold by microwave roasting

Current progress on gold recovery from refractory ore and waste electrical and electronic equipment