Abstract:There is a vast amount of globally underutilized low-grade mine tailings and leach residues, including those from primary processing of gold. In this research, the target is to recover the remaining gold (10.9 g/t) from weathered refractory iron-rich residue that had previously been subject to autoclave oxidation, subsequent cyanidation in a conventional carbon-in-leach (CIL) circuit as well as storage at tailings area. Chloride leaching has been considered as one of the most promising cyanide-free gold leaching methods and it has shown positive outcomes in treating primary gold ores, concentrates, and flotation tailings. Therefore, in the current study, the iron-rich residue investigated was subjected to chloride leaching combined with simultaneous carbon adsorption. The investigated parameters included leaching time (2–8 h), chloride concentration ( [Cl − ] = 0.2–5 M), type and concentration of oxidant ( [Cu 2+ ]/[Fe 3+ ] = 0.1–1 M), as well as type and concentration of activated carbon (14–25 g/L), whereas S/L ratio (100 g/L), acidity ( pH = 1), and temperature (90 °C) were kept constant. Leaching results indicate that up to 40% of the remaining gold could still be recovered from the investigated residue with optimized chloride leaching. According to the results, the most important parameter for gold recovery was the leaching time. Moreover, of the studied oxidants, cupric ions were shown to contribute more to gold recovery when compared to ferric ions (35% vs. 24% at [Cu 2+ ]/[Fe 3+ ] = 0.1 M). Nevertheless, an increase of cupric concentration from 0.1 M (low-concentrated) to 0.5 M, resulted in only a slight increase in gold recovery (from 36% to 40%), whereas no further improvement in gold recovery was achieved with a 1 M cupric concentration. Two studied activated carbon products showed equal effectiveness in gold adsorption. In-situ carbon adsorption was shown to occur effectively in chloride media, as all dissolved gold could be detected in the activated carbon, and the concentration of remaining gold in the pregnant leach solution was minimal (< 0.02 mg/L). These findings indicate that low-concentrated chloride leaching of leach residues from industrial gold processes can allow an enhanced recovery of gold from previously mined and treated raw materials.

Gold extraction from Carlin-type concentrate by a novel environmentally friendly lixiviant

Extraction of gold from a gold concentrate using a lixiviant synthesized by a roasting process

Reagent Elution Combined with Positive Pressure Filtration: A Zero-Discharge Method for Cyanide Tailings Remediation

A review of gold extraction using alternatives to cyanide: Focus on current status and future prospects of the novel eco-friendly synthetic gold lixiviants

A systematic review of gold extraction: Fundamentals, advancements, and challenges toward alternative lixiviants

Sustainable and effective gold(I) separation from aurocyanides wastewater and its mechanism using guanidinium ionic liquids

Sustainable processing of gold cyanide tailings: Reduction roasting, mechanical activation, non-cyanide leaching, and magnetic separation

Facile and Novel Method for the Recovery of Gold from a Calcined Concentrate Via Copper–ammonia -Thiourea System and Activated Carbon

A review of environmentally friendly gold lixiviants: Fundamentals, applications, and commonalities

Electrochemical behavior of gold dissolution with a novel eco-friendly synthetic gold lixiviant

An environmental-friendly approach to remove cyanide in gold smelting pulp by chlorination aided and corncob biochar: Performance and mechanisms

Progress in Gold Solvent Extraction

Improved thiourea leaching of gold with additives from calcine by mechanical activation and its mechanism

Gold recovery from cyanidation residue by chloride leaching and carbon adsorption – Preliminary results from CICL process

Current progress on gold recovery from refractory ore and waste electrical and electronic equipment

Optimization Role of Potassium Carbonate in the Leaching of Guizhou's Carlin-Type Gold Ore System with Potassium Chlorate

Selection of a leaching system for the extraction of gold from the ore of the Byn’govskoye deposit

Mechanism of synergistic pretreatment with eco-friendly CaO and Na 2 CO 3 to enhance gold leaching efficiency from fine-disseminated gold ores

Eco-friendly and economical extraction of gold from a refractory gold ore in iodide solution using persulfate as the oxidant

Advances in Hydrometallurgical Gold Recovery through Cementation, Adsorption, Ion Exchange and Solvent Extraction

Making untreated carbon effective in cleaner thiosulfate system: A new and high-efficiency method including gold adsorption and desorption