Abstract:There is a vast amount of globally underutilized low-grade mine tailings and leach residues, including those from primary processing of gold. In this research, the target is to recover the remaining gold (10.9 g/t) from weathered refractory iron-rich residue that had previously been subject to autoclave oxidation, subsequent cyanidation in a conventional carbon-in-leach (CIL) circuit as well as storage at tailings area. Chloride leaching has been considered as one of the most promising cyanide-free gold leaching methods and it has shown positive outcomes in treating primary gold ores, concentrates, and flotation tailings. Therefore, in the current study, the iron-rich residue investigated was subjected to chloride leaching combined with simultaneous carbon adsorption. The investigated parameters included leaching time (2–8 h), chloride concentration ( [Cl − ] = 0.2–5 M), type and concentration of oxidant ( [Cu 2+ ]/[Fe 3+ ] = 0.1–1 M), as well as type and concentration of activated carbon (14–25 g/L), whereas S/L ratio (100 g/L), acidity ( pH = 1), and temperature (90 °C) were kept constant. Leaching results indicate that up to 40% of the remaining gold could still be recovered from the investigated residue with optimized chloride leaching. According to the results, the most important parameter for gold recovery was the leaching time. Moreover, of the studied oxidants, cupric ions were shown to contribute more to gold recovery when compared to ferric ions (35% vs. 24% at [Cu 2+ ]/[Fe 3+ ] = 0.1 M). Nevertheless, an increase of cupric concentration from 0.1 M (low-concentrated) to 0.5 M, resulted in only a slight increase in gold recovery (from 36% to 40%), whereas no further improvement in gold recovery was achieved with a 1 M cupric concentration. Two studied activated carbon products showed equal effectiveness in gold adsorption. In-situ carbon adsorption was shown to occur effectively in chloride media, as all dissolved gold could be detected in the activated carbon, and the concentration of remaining gold in the pregnant leach solution was minimal (< 0.02 mg/L). These findings indicate that low-concentrated chloride leaching of leach residues from industrial gold processes can allow an enhanced recovery of gold from previously mined and treated raw materials.

Renewable ammonium chloride-induced calcium leaching of gold and copper tailings and selective preparation of vaterite CaCO 3 by CO 2 mineralization

A Green Approach to Preparing Vaterite CaCO3 for Clean Utilization of Steamed Ammonia Liquid Waste and CO2 Mineralization

Optimization of Calcium Carbide Residue Utilization for Producing High‐quality Calcium Carbonate

Activating CaCO3 to Enhance Lead Removal from Lead-Zinc Solution to Serve As Green Technology for the Purification of Mine Tailings

Reagent Elution Combined with Positive Pressure Filtration: A Zero-Discharge Method for Cyanide Tailings Remediation

Leaching behavior of copper tailings solidified/stabilized using hydantoin epoxy resin and red clay

CO2 Sequestration Based Dissolution Study of Extremely Poor Vanado-titanomagnetite Deposit Tailings

Calcium carbonate crystallization process from the mineralization of calcium chloride waste

Facile and Novel Method for the Recovery of Gold from a Calcined Concentrate Via Copper–ammonia -Thiourea System and Activated Carbon

Study on harmless treatment and valuable elements recovery of neutralization residue from acid wastewater of copper mine

Study on comprehensive utilization of tailings by using bioleaching and microbial-cementation

Novel process for deep removal of chlorine and recycling of chlorinated tailings from titanium-bearing blast-furnace slag

Green and effective remediation of heavy metals contaminated water using CaCO3 vaterite synthesized through biomineralization

A study of the preparation of Fe(OH)_3 and Mg(OH)_2 from tailings

A green and efficient utilization of refractory cyanide tailings containing inclusion gold by microwave roasting

Stripping-struvite precipitation combined process for treating high ammonia-nitrogen wastewater generated by the craft of vanadium extraction

Gold recovery from cyanidation residue by chloride leaching and carbon adsorption – Preliminary results from CICL process

Nitrogen recovery from biogas slurry with high ammonia nitrogen concentration through struvite precipitation-utilizing acid leaching solutions of collophanite tailings

Synergistic detoxification by combined reagents and safe filling utilization of cyanide tailings

Leaching of a carbonaceous gold concentrate in copper-tartrate-thiosulfate solutions

Preparation of Calcium Carbonate Nanoparticles from Waste Carbide Slag Based on CO2 Mineralization