Abstract:In the process of high-speed serial signal transmission, the performance of the entire system is often greatly affected due to the existence of jitters. Therefore, jitter has become a key factor restricting the design of high-speed digital systems [1]. This research proposes a technique to analyze jitter components using bit error rate eye diagrams. This technique is based on the generation principle of statistical eye diagrams, combined with the classification and decomposition method of jitter, and can be used to quickly extract and analyze each component of jitter. The bit error rate eye diagram data is obtained by using an experimental platform to generate a signal with a certain inherent jitter adjustable and send it to the receiving end of the platform through self-loopback. The data is analyzed to generate the corresponding bit error rate eye diagram (also called statistical eye diagram), and the probability density function (Probability density function, abbreviated as PDF) of the signal is obtained from the statistical eye diagram data. Based on the PDF analysis and calculation of the jitter signal, the random jitter (abbreviated as RJ) and the deterministic jitter (abbreviated as DJ) are separated, and the values of each component of the jitter are obtained. Compared with the set intrinsic jitter value, the jitter value calculated by this technique is within 7% error. Compared to an oscilloscope with the same bandwidth, this technique costs and consumes far less than an oscilloscope. Compared to an oscilloscope with the same bandwidth, this technique costs and consumes far less than an oscilloscope, and the results obtained are not very inaccurate.

Clock jitter measurement technique based on signal-to-noise ratio

Clock Jitter Measurement Method

Bursty Jitter In High-Speed I/O Due To Power-State Transition And Its Impact On Signal Integrity

Comparison of Clock Jitter Measurement Methods Using ADC Sampling

Effect on Pseudo Code Ranging Precision by A/D Sampling Clock Jitter

Clock Study of High Speed Interleaving/multiplexing Data-Acquisition System

Accurate and Cost-Effective Technique for Jitter and Noise Separation Based on Single-Frequency Measurement

Measurement of Clock Jitter and Distribution with Pico-Second Resolution Using ADC

Effect of Chip Rate on the Ranging Accuracy in A Regenerative Pseudo-Noise Ranging System

New method for accurate measurement of clock jitter based on equivalent-time sampling

Effect of Processing Rate on Regenerative Clock Jitter Performance in Pseudo-Random Code Ranging

Research on synchronous sampling clock jitter of power system

Simulation Research on Jitter Measurement Using CDF of ADC Output Code

Analyses of Noncommensurate Sampling Used in High-Precision Regenerative Pseudo-Noise Ranging Systems

Research of 100 Mhz Ultra-Low-Jitter Clock Generating Circuit

Practical system for phase noise measurement of optoelectronic oscillators

An Accurate and Cost-Effective Jitter Measurement Technique Using a Single Test Frequency.

Measurement of Clock Jitter in Beam Diagnostic System

How Does Crosstalk Influence the Jitter of a Clock Signal?

High-Speed Signal Jitter Measurement Method Based on Bit Error Rate Eye Diagram

A new on-chip jitter measurement method based on cumulative distribution function