Abstract:The engagement surface of the threaded connection of Oil Country Tubular Goods (OCTG) is a complex helical surface. The stress analysis of the threaded connection involves material nonlinearity, geometric nonlinearity and contact nonlinearity. It is difficult to obtain an analytical solution and the finite element method (FEM) is a powerful numerical method for solving the problem of threaded connection. Due to the complexity of three-dimensional modeling and the difficulty of computational convergence, researchers usually use two-dimensional axisymmetric finite element models to analyze the characteristic of threaded connection. However, twodimensional axisymmetric model can not efficiently simulate the stress characteristics of the threaded connection with make-up torque, which has greatly influence on the reliability of the connection, and it can not reflect the real stress state of the threaded connection. In this paper, an explicit dynamic FEM is employed and the nonlinear contact theory, nonlinear elastic-plastic stress-strain relationships and the von Mises yield criterion are considered to analyze the stress distribution of the threaded connection. As examples, three-dimensional elasto-plastic finite element models of bypass valve and drill pipe threaded connection are established. Mechanical characteristics of the threaded connections are analyzed, in which the make-up torque, axial loads and working torque are comparable with the real working conditions. It is found that the pin of bypass valve threaded connection shows a high stress and is broken when the working torque exceeds 22992.8 N center dot m. Meanwhile, drill pipe threaded connection is reliable under the most demanding load. Analysis results presented in this paper are consistent with the field observation.

A Model to Compute the Mechanical Property of Drillpipe Tool Joint and Its Application

End Stiffness Modeling for Automatic Horizontal Dual-Machine Cooperative Drilling and Riveting System

An Axial Semi-Rigid Connection Model for Cross-Type Transverse Branch Plate-to-chs Joints

Load-Carrying Capacity and Practical Calculation Method for Hollow Cylinder Joints Connected with H-Shaped Beams

Modeling and simulation of wear for alignment mechanism of large aircraft component

Numerical Analysis of the Stress Distribution and Concentration Factors of the Tool Joint of the Directional Drill Pipe

Finite Element Analysis on the Mechanical Properties of the Combined Fittings With a Long Radius and Double Elbows

Three-dimensional Finite Element Analysis of the Mechanical Properties of Helical Thread Connection

Modeling and Analysis of Dynamic Performance of Mechanical Joints Under Non-uniform Pressure Distribution

Effect of interference magnitude on ultimate strength and failure analysis of aluminium-drill-pipe-body-tool-joint-assemblies with Johnson-Cook model

Finite element modeling method of joint surfaces based on real surface pressure distribution

Deformation and Mechanical behavior of the Drill Pipe during Subsea Production Tree Installation

NONLINEAR FINITE ELEMENT ANALYSIS FOR THE ULTIMATE STRENGTH OF MULTIPLANNAR TUBULAR JOINT

Finite Element Simulations of Working Characteristics of Solid Expandable Tubular Threaded Joint

A New Method To Study The Joint Surfaces With Large Areas And Its Application In Machine Tools

Nonlinear Analysis of the Threaded Connection with Three-Dimensional Finite Element Model

Modeling and Experimental Study on Static Characteristic of BT Tool Holder-Spindle Interface

3D Mechanical Analysis of Subsea Manifold Installation by Drill Pipe in Deep Water

A multibody dynamical model of full-hole drillstring system

Bilinear Constitutive Model-Based Theoretical Study on Interfacial Properties of Pipeline Joints Coupling Tension and Temperature

Key Technologies of Finite Element Modeling of Machine Tools Based on ANSYS Platform