Abstract:The productivity, surface finish, and dimensional accuracy during machining are directly related to the vibration characteristics of tool tip. Moreover, the dynamics of tool tip is not only determined by the flexibility of tool, collet, holder and spindle, but also depends on the contact characteristics of joint interfaces. This paper proposes a fully analytical model of the spindle-holder-tool system considering the nonlinear contact characteristics of joint interfaces. The dynamics of spindle, holder, collet and tool are modeled applying Timoshenko beam theory considering the combined shear and rotational effects, in which the tapered sections of spindle, holder and collet are modeled using multi-stepped beam to account for the taper effect. Under highly dynamic cutting load, the variation in the spacing of joint interfaces will induce the changes in the contact characteristics due to the corresponding vibrations. Therefore, the contact behaviors of spindle/holder, collet/holder, collet/nut, and tool/collet interfaces are analytically modeled using the distributed nonlinear spring-damping layers. The fractal theory and the slicing method are applied to derive the vibration displacement-dependent stiffness matrix of nonlinear springs in joint interfaces considering the surface morphology, geometry, material properties, and locking force of joint interfaces. Furthermore, the five degree of freedom (DOF) nonlinear stiffness model of the spindle-bearing joint dependent on vibration displacement is also considered. The effectiveness of the established analytical dynamic model is verified through vibration testing and modal hammering experiments. The changes in the vibration characteristics by considering the connection ways of joint interfaces, the fractal parameters of joint interfaces and the rotation speed are also investigated. The developed model can provide some theoretical principles for the optimization at design stage without prototypes.

Modeling and Experimental Study on Static Characteristic of BT Tool Holder-Spindle Interface

Finite Element Analysis of Spindle Thermal Character Based on Thermal Contact Resistance

A virtual material-based static modeling and parameter identification method for a BT40 spindle–holder taper joint

End Stiffness Modeling for Automatic Horizontal Dual-Machine Cooperative Drilling and Riveting System

Optimization for the Connection Parameters of Hsk Tool Shanks

The Design Study of Single Plane Vertical Hard Bearing Dynamic Balancing Machine

Dynamic Modeling and Parameters Identification of a Spindle–holder Taper Joint

Characteristics of stiffness and contact stress distribution of a spindle-holder taper joint under clamping and centrifugal forces

Investigation of machine tool rigidity through measurements and FEA

Modelling and Characteristic Investigation of Spindle-Holder Assembly under Clamping and Centrifugal Forces

A fully analytical nonlinear dynamic model of spindle-holder-tool system considering contact characteristics of joint interfaces

Dynamic modeling and experimental research on position-dependent behavior of twin ball screw feed system

Dynamics Prediction of Spindle System Using Joint Models of Spindle Tool Holder and Bearings

STATIC STIFFNESS RESEARCH AND OPTIMIZATION ON A HYBRID MACHINE TOOL CONSIDERING THE STIFFNESSES OF BEARINGS AND GUIDEWAYS

Dynamic Analysis and Optimization of Machine Tool in Consideration of Joint Parameters

Dynamic Characteristics Analysis and Finite Element Simulation of Steel–BFPC Machine Tool Joint Surface

Dynamic Modeling and Experiment Research on Twin Ball Screw Feed System Considering the Joint Stiffness

A novel approach for preload measurement and analysis of fixed position preload spindle

A FE Modelling Method for the Thermal Characteristics of High-Speed Motorized Spindle

Thermal effect modeling of axial static stiffness of motorized spindle unit

Simulation, Experiment and Optimization for Thermal Characteristics of a Machine Tool Spindle System