Abstract:Transparent conductive CuCrO2 oxide films were prepared on sapphire substrates by the sol–gel method using copper (II) acetate monohydrate and chromium (III) nitrate hydrate as raw materials. The highly c-axis orientation and optical transparency (60–80%) in the visible region were obtained. The microstructure, vibration modes, optical and electrical transport properties as a function of annealing temperatures have been systematically discussed. With increasing annealing temperature, the crystalline quality and the c-axis orientation of CuCrO2 films were improved, which induced the increase of Raman phonon amplitude with the decrease of the linewidth. But the film compactness and density decrease with the increase of average particle size. In order to study the intrinsic mechanism of the optical response behavior, a three-phase layered structure (air/film/substrate) was applied to simulate the transmittance spectra of CuCrO2 films. Three electronic transitions can be uniquely assigned and it is found that the direct transitions are the dominant effect for CuCrO2 optical properties. The temperature dependence of electrical conductivity was studied and the electrical conduction mechanisms of the thermal activation behavior and the three-dimensional variable range-hopping transport were observed. In addition, the conductivity of CuCrO2 films decreases with increasing annealing temperature induced by its microstructure and the grain boundary scattering. Thus, the film annealed at 600 °C has the largest electrical conductivity of 0.49 S m−1 at room temperature. The present results could be crucial and provide theoretical support for future applications of p-type semiconductor and optoelectronic devices.

Optical Properties Of Cucl+-Implantation And Observation Of Sub-Micrometre Particles In Alpha-Al2o3 Crystals

Effect of Annealing Temperature and CuO on Microstructure and Optical Band Gap of CuxZn1−xO Thin Films

Optical and Wetting Properties of CuAlO2 Films Prepared by Radio Frequency Magnetron Sputtering

Effects of Eu Ions Dose and Annealing Temperature on the Structural and Optical Properties of Eu-implanted AlN Thin Films

Spectral Properties of Ni+-implanted Single Crystals α-Al2O3

Observation Of Redshifts Of Photoluminescence From Thin Films Assembled By Cucl Nanoclusters

Preparation and characterization of CuAlO<sub>2</sub> transparent thin films prepared by chemical solution deposition method

Optical Characterization of Ion-Implanted 4H-SiC

Effect of annealing temperature on structural, optoelectronic properties and interband transitions of CuCrO2 nanocrystalline films prepared by the sol–gel method

Preparation and characterization of CuAlO 2 transparent thin films prepared by chemical solution deposition method

Al-implantation induced damage in 4H-SiC

The Reduction of Cu2+ to Cu+ and Optical Properties of Cu+ Ions in Cu-doped and Cu/Al-codoped High Silica Glasses Sintered in an Air Atmosphere

A comparative study on the effects induced following xenon ion implantation at high energies on the electrical, morphological and optical properties of CuInSe 2 monocrystalline

Implantation Study of Carbon Clusters Cn+(n=1—5) into NaCl Crystal

Change of Sheet Resistance of High Purity Alumina Ceramics Implanted by Cu and Ti Ions

Optical Properties of Metallic Nanoparticles in Ni-ion-implanted Α-Al2o3 Single Crystals

Microstructure Evolution of AlN:Eu Films at Different Annealing Temperatures

Experimental study on the transmission spectra of CuCl microcrystals

Infrared Reflection Investigation of Ion‐implanted and Post‐implantation‐annealed Epitaxially Grown 6H‐sic

Mechanical Properties and Structure Evolution of Single-Crystalline Silicon Irradiated by 1 MeV Au+ and Cu+ Ions

Structure and Reflective Properties of Al-Cu-Fe Quasicrystalline Thin Film Prepared by Laser Induced Arc Method