Abstract:Two kinds of adsorbates—L-ascorbic acid and NaOH were used separately to investigate the effects of adsorbate distribution between ethanol bulk phase and the phase of water-rich layer adsorbed by the surface of SiO2 particles on the preparation of silver nanoparticles on SiO2 particles. When the adsorbate L-ascorbic acid was used, L-ascorbic distributes mainly in the ethanol bulk phase and thus the Ag particle generating reaction will take place in the ethanol bulk phase with the generated Ag particle size of about 18 nm. When the adsorbate NaOH was used, NaOH distributes mainly in the phase of water-rich layer adsorbed on the surface of SiO2 particles and thus the Ag particles generate in the water-rich adsorption layer with particle size of only about 5.4 nm. Since the NaOH concentration effects its distribution between the two phases of ethanol bulk phase and water-rich adsorption layer, the further experiments with changing NaOH concentration in the reaction system from 0.0170 to 0.404 g·L-1 were conducted. Results show that when concentration of NaOH in the system was increased from 0.0170 to 0.135 g·L-1, the NaOH concentration in the water-rich adsorption layer increases with the increase of NaOH concentration in the system gradually, which causes the generation of Ag grains gradually centralizes in the adsorption layer with the grain size decreases from 8 nm to 5 nm, and the Ag particles generated cover the SiO2 more uniformly. When NaOH concentration in the system was increased from 0.135 to 0.404 g·L-1, the amount of NaOH in the system is over the maximum NaOH capacity that can be contained in the water-rich adsorption layer and thus the NaOH concentration in ethanol bulk phase will increase to the limit, above which, the Ag generating reaction rate in it will accelerate more quickly than that in the water-rich adsorption layer, which causes the main generation zone of silver nanoparticles moves from water-rich adsorption layer to ethanol bulk phase gradually, and at the same time, the generated Ag grain size will increase from 5 nm to 12 nm.

Analysis on the particle size information in sodium aluminate solution during seeded agglomeration

Homogeneous and Heterogeneous Nucleation of Potash Alum in Drop-Based Microfluidic Device

Effect of Interphase Distribution of Reactants in Binary Liquids on Preparation of Silver Nanoparticles on Silica Particles

Influences of Seeds on the Properties of Zeolite NaA Membranes on Alumina Hollow Fibers

Effect of Particle Size on Properties of Alumina-Based Ceramic Cores

Preparation of Near-Spherical α-Al2O3 Particles by Enhanced Precipitation of Gibbsite from Sodium Aluminate Solution Using Highly Dispersed Al2O3 as Seeds

Preparation of Near-Spherical α-Al 2 O 3 Particles by Enhanced Precipitation of Gibbsite from Sodium Aluminate Solution Using Highly Dispersed Al 2 O 3 as Seeds

Synthesis and sintering behavior of a nanocrystalline α-alumina powder

Size-controlled synthesis of nano α-alumina particles through the sol–gel method

Preparation and characterisation of seed for simultaneous removal of sulphur and iron from sodium aluminate solution

Modeling of particle agglomeration in nanofluids

Secondary Nucleation Of Aluminium Trihydroxide In Bayer Sodium Aluminate Solution

Synthesis of Nano-Alumina Hydroxide Sol Using Sol-gel Method

Effect of Polyamidoamine on Surface Tension and Seed Precipitation in Sodium Aluminate Solution

A Kind Of Activity Seed Used For The Precipitation Of The Sodium-Aluminate Liquor

Influence of Α-Alumina Seed on the Morphology of Grain Growth in Alumina Ceramics from Bayer Aluminum Hydroxide

Structural reconstruction and thermophysical properties of alumina agglomerate based on QSGS calculation

Influence of Alumina Slurry on Morphology of Microspheres by Spray Drying

Effect of impurity ions on the primary nucleation of ammonium alum precipitated from aqueous solution

Formation and Control of Agglomerates in Alumina Powder

Controllable Preparation Conditions of Monodisperse γ-Al2O3 Nanoparticles