Abstract:Due to their special appearance, spherical α‐Al2O3 nanoparticles play an important role for obtaining high performance structural and functional ceramics. However, there are still problems such as easily agglomerates to form worm‐like structures at high temperatures and difficult availability of spherical nanoparticles. In this study, spherical α‐Al2O3 nanoparticles with high dispersion were prepared by combination of microwave hydrothermal method and addition of nano‐Al particles as seeds. Firstly, spherical amorphous alumina precursors were synthetized by microwave hydrothermal method at 100°C for 30 min using Al2(SO4)3∙18H2O, Al(NO3)3∙9H2O and urea as raw materials, and then, spherical α‐Al2O3 nanoparticles with diameter of about 66 nm were acquired after calcined the precursor at 1050°C for 90 min by adding nano‐Al seeds, which reduced the calcination temperature by 50°C and holding time by 30 min compared to that without seeds. Kinetic analysis shows that 5 wt.% nano‐Al seeds can reduce the activation energy of crystalline transition of γ‐Al2O3 to α‐Al2O3 from 516.51 kJ/mol to 474.37 kJ/mol. Moreover, the microscopic mechanism of nano‐Al particles as seeds was investigated. The characterizations of sintering properties show that spherical α‐Al2O3 nanoparticles facilitate the acquisition of uniform microstructure for resulting ceramic and the fracture modes include both intergranular and transgranular fracture.This article is protected by copyright. All rights reserved

Influence of Α-Alumina Seed on the Morphology of Grain Growth in Alumina Ceramics from Bayer Aluminum Hydroxide

Influence of α-alumina seeds on transformation of aluminum hydroxide and morphology of alumina grain in hot-pressing

Imfluence of alpha-alumina seeds on transformation of aluminium hydroxide and morphology of alumina grain in hot-pressing

Influence of Different Seeds on Transformation of Aluminum Hydroxides and Morphology of Alumina Grains by Hot-Pressing

High Toughness Alumina Ceramics with Elongated Grains Developed from Seeds

High fracture toughness alumina ceramic materials by elongated grains toughening from induced-seeds

High fracture toughness alumina ceramic materials by elongated grains toughening from induced- seeds

SINTERING PROCESS OF ALUMINA CERAMICS WIH PLATE-LIKE ALUMINA SEEDS

Effect of Seedings on the Microstructure of Hydrated Alumina

Preparation of α-Al2O3 by low-temperature calcining γ-Al2O3 with α-phase seed in-situ obtained by ball milling

Influences of Seeds on the Properties of Zeolite NaA Membranes on Alumina Hollow Fibers

Production of ultrafine alpha alumina powders and fabrication of fine grained strong ceramics

Synthesis, Evaluation And Characterization Of Alumina Ceramics With Elongated Grains

Synthesis and sintering behavior of a nanocrystalline α-alumina powder

Advances of Abnormal Grain Growth to Toughen Al2o3 Ceramics

Effect of Aluminum Nanopowder on Growth and Morphology of Alumina Grain

Preparation of spherical α‐Al 2 O 3 nanoparticles by microwave hydrothermal synthesis and addition of nano‐Al seeds

Optimization of growth theory of the directionally solidified alumina based eutectic ceramics

Influence of starting materials on plate-like alumina synthesized by molten salt method

Friction and wear performance of Al2O3 ceramics with elongated grains

Preparation and Analysis of Mechanism of the High Fracture Toughness Alumina Ceramics with the Cheap Commercial Aluminum Hydroxide