Abstract:Titanium aluminides are candidates for replacing nickel superalloys in some aircraft engine components. In uniaxial tension tests, these materials experience plastic strains at failure that place them in-between traditional definitions for ductile and brittle materials. This study considers the appropriate continuum mechanics failure criterion for these materials under multiaxial loading conditions (based on either the maximum equivalent plastic strain or the maximum normal stress). The material tested is a Ti-47.0Al-2.0Cr-1.9Nb alloy having a predominantly lamellar γ/α 2 microstructure. Cylindrical notched tensile specimens that experience elevated normal stresses in their interiors due to circumferential constraint during plastic deformation have been investigated. Results are presented that quantify reductions in failure loads due to elevated normal stress, compared to those predicted by finite element models using a maximum equivalent plastic strain criterion. To properly interpret the experimental results, the effects of notch strengthening must be included in the model predictions. Model and experimental results suggest that this TiAl alloy has some sensitivity to normal stress and that a combined failure criterion is needed to accurately predict failure under multiaxial loading conditions. A fracture initiation and failure mechanism requiring a combination of normal stress and plastic straining is suggested that is consistent with observed features at fracture initiation sites.

An Investigation of Small-crack and Long-crack Propagation Behavior in Titanium Alloy TC4 and Aluminum Alloy 7475-T7351

Effects of Tensile/compressive Overloads on Fatigue Crack Growth Behavior of an Extra-Low-interstitial Titanium Alloy

Instrumented indentation measurements of residual stresses around a crack tip under single tensile overloads

DIC-based Studies of the Overloading Effects on the Fatigue Crack Propagation Behavior of Ti-6Al-4V ELI Alloy

Small Crack Growth Behavior And Life Prediction Of 7075-T73 Forged Aluminum Alloy

Cracking in a Fe–25Mn–3Si–3Al Steel

A Study on Fatigue Crack Closure Associated with the Growth of Long Crack in a New Titanium Alloy

The Effect of Constraint-Induced Normal Stress on the Failure of Notched TiAl Components

Influence of notch root radius on high cycle fatigue properties and fatigue crack initiation behavior of Ti-55531 alloy with a multilevel lamellar microstructure

Fracture Characteristics of Notched Investment Cast TiAl Alloy Through in Situ SEM Observation

Investigation on Fatigue Threshold Testing Methods in a Near Lamellar TiAl Alloy

EVALUATION OF SMALL CRACK GROWTH RATE OF ALUMINUM ALLOYS UNDER DIFFERENT STRESS GRADIENTS

In situ observation of crack propagation in lamellar TiAl/Ti3Al structure

Crack initiation and propagation in Ti-6Al-4V-0.55Fe alloy subjected to the low-cycle dwell-fatigue

Atomic simulation of the orientation effects on crack tip behavior in titanium single crystal

Near-tip Strain Evolution and Crack Closure of Growing Fatigue Crack under a Single Tensile Overload

Effects of notch width and loading rate on the dynamic mode II fracture toughness of Ti-6Al-4V

Small Punch Testing of a Ti6Al4V Titanium Alloy and Simulations under Different Stress Triaxialities

Fatigue cracking behavior and life assessment of TC11 titanium alloy in very high cycle regime at two working temperatures

Comparison on crack propagation under tension at 150 °C of Mg-2Zn-1.5Mn alloy sheets with and without crack notch

Effects of Al on crack propagation in titanium alloys and the governing toughening mechanism