Abstract:In the present paper, the Al–Fe-Mo phase diagram was studied by X-ray diffraction (XRD), differential thermal analysis, differential scanning calorimetry, scanning electron microscopy and electron probe microanalysis. For the first time, isothermal sections at 1450, 1300 and 1200 °C were experimentally determined over the entire range of compositions. A ternary intermetallic compound τ (Mo 3 FeAl 8 ) with a TiAl 3 -type structure was observed at all above temperatures. It has been shown that isostructural disordered bcc (A2) phases of pure elements Fe and Mo (W-type structure, cI 2 - in the ternary system at 1450 °C form a continuous solid solution (Mo,Fe,Al), dissolving up to 50 at.% Al. When cooled, it decomposes into a Mo-rich part and an elongated area (Fe,Al) along Fe-Al side. As the temperature decreases, their homogeneity regions reduce in size and shift toward higher Mo and Fe contents, respectively. The μ (Mo 6 Fe 7 ) phase, which in the Fe-Mo binary system is formed in the solid state at 1368 °C, deeply extends into the ternary system, up to 16 and 15 at.% at 1300 and 1200 °C, respectively, where Al substitutes for Fe. Since the addition of Mo stabilizes the ε (Fe 5 Al 8 ) phase, and the temperature of its formation in the ternary system is higher than in the binary (1331 and 1234 °C, respectively), the isothermal section at 1300 °C contains a narrow homogeneity region of this phase. In contrast, the solubility of Mo in ε at 1200 °C is no less than 14.4 at.%. The boundary Al-Mo binary and Al–Fe-Mo ternary systems are thermodynamically remodeled based on our experimental results and novel information reported in literature. Thermodynamic modeling was carried out by the CALPHAD (CALculation of PHAse Diagrams) approach using Thermo-Calc software. Calculations performed using the proposed thermodynamic description well reproduce most of the experimental data, including data from the available literature. Based on the developed description, phase diagrams of the constituent binary systems, as well as liquidus and solidus projections, selected isothermal and isopleths sections and the reaction scheme of the ternary system were calculated.

Experimental Investigation and Thermodynamic Calculation in the Al-Be-Si Ternary System

A thermodynamic description of the Al–Fe–Si system over the whole composition and temperature ranges via a hybrid approach of CALPHAD and key experiments

Phase Equilibria of the Cu-Se-Te Ternary System

Thermodynamic Modeling of the Bi-Se and Bi-Te Binary Systems

THERMODYNAMIC ASSESSMENT OF THE Fe-Nb-Si SYSTEM

Thermodynamic descriptions of quaternary Mg–Al–Zn–Bi system supported by experiments and their application in descriptions of solidification behavior in Bi-additional AZ casting alloys

Theoretical Investigation of Thermodynamic Properties of the Al-Si-Fe Ternary Alloy

Thermodynamic Descriptions of the Quaternary Mg–Al–Zn–Sn System and Their Experimental Validation

DSC Investigation and Thermodynamic Modeling of the Al–Sb–Sn System

Experimental study on phase relations in the Al-Mo-Nb ternary system

Experimental Investigation and Thermodynamic Calculation of Phase Equilibria in the Mg-Pb-Sn Ternary System

Experimental determination of the phase equilibria of aluminum-rich Al−Li−Cu alloys

Thermodynamic evaluation and optimization of the K2O‐Al2O3‐SiO2 system

Thermodynamic re-modeling of the binary Al–Mo and ternary Al–Fe–Mo systems based on novel experimental data

Experimental Investigation of Phase Equilibria in the Co-Ta-Si Ternary System

Critical Evaluation and Thermodynamic Re-Optimization of the Si–P and Si–Fe–P Systems

Experimental Investigation and Thermodynamic Modeling of the Mg–Sn–Sr Ternary System

Thermodynamic Assessments of the Al2O3-Al4C3-AlN and Al4C3-AlN-SiC Systems

Thermodynamic investigation on the Al2O3–BaO binary system

Phase Equilibria of Sn–Sb–Cu System

Thermo-Calc Determination of Phase Diagram of Si-B Binary System