Abstract:In the present work, phase equilibria in the Li O–Al O system were experimentally studied and calorimetric measurements were performed. Based on obtained results and data from literature, thermodynamic parameters of the system were assessed. The solid solution phases were modeled using Compound Energy Formalism (CEF) and liquid phase was described by two-sublattice partially ionic liquid model. The experimental investigations for selected compositions of isothermally heat-treated samples were performed using x-ray Diffraction (XRD) and Scanning Electron Microscopy (SEM). Differential Thermal Analysis (DTA) and Differential Scanning Calorimetry (DSC) were used to measure the temperature of the reactions as well as the heat capacities, respectively. After DTA, the microstructure was analyzed using SEM. Temperature of peritectic melting of h-LiAl O was determined to be 2222 K and temperature of eutectic reaction Liq -LiAlO + h-LiAl O to be 1965 K. Heat capacity of LiAlO and LiAl O was measured in the temperature range of 100-1300 K. The degree of inversion of spinel phase (Al , Li ) :(Al , Li , Va) :O was modelled assuming Al and Li can occupy tetrahedral (T) and octahedral (O) cationic sublattices while its composition extension in Al O enriched region was described by introducing vacancies in octahedral sites. Thermodynamic description derived in the present study reproduces the degree of inversion close to that of the high-temperature spinel phase, which means that Al ions preferentially occupy the tetrahedral sites. The calculated phase diagram satisfactorily agrees with the experimental results. Available experimental thermodynamic data are also reproduced within uncertainty limits.

Thermodynamic investigation on the Al2O3–BaO binary system

Thermodynamic Optimization of BaO-MgO Binary System

Thermodynamic Re-Assessment of the Mn-La Binary System

Thermodynamic evaluation and optimization of the K2O‐Al2O3‐SiO2 system

Phase equilibrium investigations of the Al2O3–Ta2O5 system: New experiments and thermodynamic modeling

Experimental Investigation and Thermodynamic Modeling of the Li O–Al O System

Assessment of the thermodynamics and phase diagram of the SrO-B2O3 system

First-principles Investigation of the Structural, Mechanical and Thermodynamic Properties of Al2Cu Phase under Various Pressure and Temperature Conditions

Experimental investigation and thermodynamic assessment of the Na2O–Al2O3–CaO system

Thermodynamic Description of the MCl2-ThCl4 (M: Mg, Ca, Sr, Ba) Systems

Thermodynamic descriptions of the CaO–Al2O3 and CaO–Al2O3–SiO2 systems over the whole composition and temperature ranges

Thermodynamic Modeling of the Bi-Se and Bi-Te Binary Systems

Thermodynamic Basis and Related Phase Equilibria for In-Na and In-Ca Binary Systems

Experimental Investigation and Thermodynamic Assessment of Phase Equilibria in the Al-Ta-V Ternary System

Thermodynamic Assessments of the Al2O3-Al4C3-AlN and Al4C3-AlN-SiC Systems

DSC Investigation and Thermodynamic Modeling of the Al–Sb–Sn System

First-principles calculations, experimental study, and thermodynamic modeling of the Al-Co-Cr system

Thermodynamic Modeling of Al–Fe–V Ternary System

Experimental Measurements and Thermodynamic Optimization of the NaCl+RbCl Phase Diagram

Thermodynamic Calculation of Phase Equilibria in the C-Mo-Zr System

Ab initio and CALPHAD-type thermodynamic investigation of the Ti-Al-Zr system