Abstract:Molybdenum disulfide (MoS2) films are widespread application in aerospace, nuclear, mechanical, and electronic fields owing to their unique structural characteristics and inherent interlayer slip. However, their utility is hindered by environmental susceptibility, particularly oxidation at elevated temperatures and in humid environments, limiting their effectiveness. Herein, we report a nanocomposite integrating MoS2 with WB2 by periodic alternating arrangement, synthesized using magnetron sputtering technology. This nanolayered architecture effectively harnesses the synergistic properties of both materials, imparting exceptional mechanical properties, superior environmental adaptability and efficient high -temperature lubrication. Methodical experiments and atomistic simulations reveal the incorporation of WB2 promotes preferential growth of MoS2 along the (002) plane, yielding an impressive hardness -to -elastic modulus ratio of approximately 0.1. The resultant film demonstrates notable achievements: a minimal friction coefficient of 0.056 and a specific wear rate of 1.88 x 10-7 mm3 N-1 m- 1 in humid air. These findings are primarily stem from the interaction between MoS2 nanosheets and metal -oxide nanoparticles at the sliding interface. Remarkably, even at 400 degrees C, the engineered MoS2/WB2 nanocomposite achieves low friction and wear under high contact stress, outperforming conventional MoS2- based materials. This innovative design, complemented by insights into the high -temperature friction mechanism, holds promise for advancing the development of robust and high -temperature -resistant lubricants.

Study of Tribological Characteristics of WS2 in High Temperature Lubricating Grease

Tribological Performance of High Temperature Grease Containing WS_2 Submicron Particles

Study of the Development of a WS2 High-Temperature Lubricating Grease

The Thermal Stability and Lubricity of Zinc Thiomolybdenate at Temperatures Up to 500°C

Influences of WS2 Powder Additive on the Tribological Characteristics of High-Temperature Lithium Soap Grease

Excellent Tribological Performance at Elevated Temperatures and Associated Mechanisms of Novel AlCoCrFeNi-MoS2 Solid Self-Lubricating Composite

Effect of Superfine WS_2 Powder on Performances of High Temperature Lithium Complex Grease

STUDY ON THE TRIBOLOGICAL PROPERTY OF ULTRA-FINE WS_2 POWDER IN MOTOR OIL

Tribological Behavior of WS2 Nanoparticles as Additives in Calcium Sulfonate Complex–Polyurea Grease

WS2 Nanopowders As High-Temperature Lubricants: an Experimental and Theoretical Study

Study on the tribological property of ultra-fine WS2 powder in motor oil

Study on Tribological Characteristics of Ultrafine WS2 Powders in Petrol Engine Oil

Study on the Influence of the MoS2 Addition Method on the Tribological and Corrosion Properties of Greases

High-Temperature Superlubricity in MoS 2 /Graphene van der Waals Heterostructures

Study on Tribological Performances of MoS2 Coating at High Temperature

Investigation of the Tribological Properties of Two Different Layered Sodium Silicates Utilized As Solid Lubrication Additives in Lithium Grease

Study on Atmospheric Tribology Performance of MoS2–W Films with Self-Adaption to Temperature

Study on the High Temperature Tribological Properties of Ni-Cr Based Alloys Containing MoS2

Dependence of High Temperature Tribological Performance of Mos2-Based Composites on Type of Oxides

Enhancing Mechanical Performance and High-Temperature Lubrication Enabled by MoS2/WB2 Nanolayered Films

Preparation and tribological properties of multi-layer graphene/silicon dioxide composites-based solid lubricant coatings at elevated temperatures