Abstract:Advances in Mechanical Engineering, Volume 16, Issue 5, May 2024. The large-capacity power flywheel energy storage system serves as a high-quality frequency modulation resource for the power system. Utilizing high-strength, low-density composite materials in the manufacture of flywheel rotors is a primary method for enhancing flywheel energy storage. In this paper, we focus on the large-size multi-ring composite flywheel rotor. Based on the elastic theory, the stress distribution formula of the anisotropic material rotor rim under high-speed rotation is derived. Based on the stress superposition principle, the stress analysis formula under the interference fit of the composite rim and the metal hub is obtained, and the analytical solution is given. Based on the radial displacement of each ring, a suitable amount of interference is determined. Subsequently, a finite element analysis model for the interference fit between the composite rim and the metal hub is established. The stress distribution of the rotor is simulated and analyzed. The simulation results are basically consistent with the analytical results, which verifies the rationality of the model. Finally, we analyze and compare the difference between multi-ring isomorphism and multi-ring isomerism, and then the applicability of the analytical solution and simulation solution to the stress distribution of three-ring and four-ring composite flywheel rotor is further verified. The results demonstrate that, for large-size composite flywheels, existing formula analysis calculations and finite element simulation calculations align, highlighting a need for experimental verification in future research.

3D NUMERICAL ANALYSIS OF INITIAL STRESS OF COMPOSITE FLYWHEEL FABRICATED BY FILAMENT TENSION WINDING

Numerical Simulation of Whole Process and States of Tensile Membrane Structure

Mechanical Analysis of Carbon Fiber Wound High Pressure Hydrogen Storage Vessel and Prestress Control in Manufacturing Process

Influence of Filament Winding Tension on the Deformation of Composite Flywheel Rotors with H-Shaped Hubs

A Comparison of Analysis Flywheel Stress Distributions Based on Different Material

Non-orthogonal FE model with stress smoothing for progressive damage analysis of shear pre-deformed 3D angle-interlock woven composites under compression

Experimental and Numerical Study on Failure Behaviors of Composite Grid Stiffeners under Tensile and Flexural Loading

THE STRUCTURAL ANALYSIS METHOD OF WIND TURBINE BLADE BASED ON MECHANICS OF COMPOSITE MATERIALS

NUMERICAL SIMULATION OF STIFFNESS DEGRADATION MODEL FOR FIBER-WINDING COMPOSITE PRESSURE VESSELS

Theoretical analysis for the axial tensile response of the mesoscopic model for filament-wound composites

Simulation analysis of multi-ring interference assembly of large capacity composite flywheel rotor

Analytical Prediction and Numerical Verification of Stress Concentration Profile Around an In-situ Tow Break in Resin-impregnated Filament-wound Composites

A NUMERICAL MODEL OF WOVEN FABRIC COMPOSITES

A novel modeling method for the mechanical behavior of 3D woven fabrics considering yarn distortion

An Analytical Model for the Uniaxial Tensile Modulus of Plain-Woven Fabric Composites and Its Application and Experimental Validation

Micro-mechanical damage simulation of filament-wound composite with various winding angle under multi-axial loading

A numerical simulation approach for the residual prestress of composite barrel with non-round section of railgun with tension winding

Numerical simulation of 3D angle-interlock woven fabric forming and compression processes

Finite element modeling and simulation of yarn in winding process

Tension relaxation during the NOL ring winding process based on a novel tracking element method

Pre-stress Test for Steel Wire Wound Moving Beam of Heavy Forging Press Based on Finite Element Method