Predictive DTC Strategy With Fault-Tolerant Function for Six-Phase and Three-Phase PMSM Series-Connected Drive System
Yangzhong Zhou,Guangtuan Chen
DOI: https://doi.org/10.1109/tie.2017.2786236
IF: 7.7
2018-11-01
IEEE Transactions on Industrial Electronics
Abstract:On the one hand, with the use of direct torque control (DTC) for a six-phase permanent magnet synchronous motor (PMSM) and a three-phase PMSM series-connected system supplied by a six-phase inverter, it is possible to realize fast torque control for two PMSMs. On the other hand, because the number of inverter output voltage vectors (VVs) is increased to 64, it is difficult to divide sectors for traditional switching table DTC (ST-DTC). Furthermore, it is difficult to choose an optimal switching vector to reduce torque and flux ripples of two PMSMs in ST-DTC. A predictive control strategy of torque and stator flux is introduced into a two-PMSM series-connection DTC system, including winding fault, in this paper. Based on the principle of minimum errors of torque and stator flux amplitude and minimum zero-sequence current, an optimal VV is predicted. In order to realize uninterrupted torque control before and after open-phase fault, open-phase winding flux is considered in stator flux, and the inverter VV considering open-phase voltage is constructed in an open-phase control strategy. The experimental results show that the steady-state torque and stator flux ripples of a series-connected drive system are greatly reduced, and the drive system can operate without interruption from failure-free to failure operation.
automation & control systems,engineering, electrical & electronic,instruments & instrumentation