Abstract:Following the general guidance on the influence of the machining polarity in micro-EDM, usually a straight polarity is applied (with the tool electrode being connected to the negative pole of the generator output), since the bombarding of the “light” electrons on the workpiece is assumed to be the primary material removal mechanism. Therefore, a flipping of the polarity in the micro-EDM machining process shall result in a high volumetric relative wear, which has been experimentally verified. The initial objective of this research is to reduce the tool wear by inserting a diode in the discharge circuit to block the reverse current flow. However, in the experiments an even higher volumetric relative wear has been observed with the inclusion of a diode. To investigate in depth the influence of the alternating current flow on the tool-material interaction, a pulse counting method based on the detection of the current peak has been proposed to count the number of effective pulses. This counting of the effective sparks enables the subsequent analysis of the mean material removal per discharge and tool wear per discharge. The analysis of the measurements obtained in both sparking cases, with a diode and without a diode, indicates that the reverse current is contributing positively to the material removal on the workpiece and the volumetric relative wear. Therefore, it is not economically proper to block the reverse the current flow in micro-EDM milling. At lower open voltage, the simple empirical linear model without reverse current flow can still serve as a reference for the in-situ tool wear prediction and the subsequent tool wear compensation. However, a correction to the model has to be made at a setting of higher open voltage.

Dual-Channel MOSFET Sub-Microsecond Micro-Energy Pulse Power Source Used in Electrical Discharge Machining

A study on pulse control for small-hole electrical discharge machining

Parallel Resonance Pulse Generator for Micro Wire Electrical Discharge Machining (WEDM)

Research on Pulse Generator and Pulse Control Technology for Micro Electrical Discharge Machining

Pulse Dynamic Regulation of Electrochemical Discharge Milling by Utilizing the Slotted Tube Electrode

Research on A High Frequency Micro Energy Pulse Power Source for Micro-EDM

Pulse power supply with pico-joule energy for micro-EDM machining

Research on Feed-Pulse Collaborative Control Method in Micro-Electrical Discharge Machining

Pulsed Power Supply Superposed With Radio Frequency Oscillating Wave for the Improvement of Micro-Electrical Discharge Machining Process

Machining Properties Of Micro Edm Using Electrostatic Induction Feeding

Research on Energy-Saving EDM Pulse Power Supply

Study of Alternating Current Flow in Micro-Edm Through Real-Time Pulse Counting

Ns-pulsewidth Pulsed Power Supply by Regulating Electrical Parameters for AFM Nano EDM of Nm-Removal-resolution

Experimental Investigation on the Discharge Stability in Micro-Edm Based on Finite-Successive Pulses Discharge Method

Study on characteristics of EDM using pulse power supply with active high-frequency oscillation

Energy Saving Effect Analyzing of EDM Pulsed Power Supply with Cyclically Superimposed Chopper Circuit

A Novel Power Supply for High Speed Drilling Electrical Discharge Machining Base on Pulsed Width Modulated

Pulsed Power Supply Superposed with RF Oscillating Wave for the Improvement of Micro EDM Process

A discharge plasma regulation method with spike current for electrical discharge machining

A Discharge Pulse Discrimination Strategy for High Speed WEDM with Power-Electronic-based Pulse Power Generator

Design, Simulation, and Characterization of a Low-Cost In-Plane Spark Gap Microswitch with Dual-Trigger Electrode for Pulsed Power Applications.