A discharge plasma regulation method with spike current for electrical discharge machining
Qiang Gao,Ke-Lin Li,Ling Qin,Ya-Ou Zhang,Xue-Cheng Xi,Wan-Sheng Zhao
DOI: https://doi.org/10.1016/j.jmapro.2024.07.058
IF: 5.684
2024-07-25
Journal of Manufacturing Processes
Abstract:Improving material removal rate (MRR) has been one of the most important issues in electrical discharge machining (EDM). A major factor which hinders the improvement of MRR in EDM is the relatively low expulsion ratio of molten material. During a discharge process, a large portion of molten material cannot be expelled sufficiently from the molten pool but re-solidifies, ultimately resulting in a low machining efficiency. In this study, aiming at enhancing the expulsion ratio of molten material in EDM, a discharge plasma regulation method with a spike current is proposed. A novel discharge pulse shape, with a spike current aligned at pulse turn-off stage, is adopted. The transient behaviors of the discharge plasma when a spike current engaged are captured using a high-speed camera, and the morphologies of the corresponding discharge craters are also analyzed. A particle-in-cell with Monte Carlo collision simulation method is used to analyze the changes in particle state inside the plasma. It is found that the spike current applied at the stage when the plasma contracts to a smaller diameter is more conducive to facilitating molten material expulsion. The results of consecutive-pulse machining experiments verify that the proposed discharge plasma regulation method can increase MRR by at least 25.89 % for stainless steel.
engineering, manufacturing