Abstract:The gas-solid vertical single helical ribbon agitated reactor is widely used in the polypropylene industry. The gas flow and mass transfer determine the heat transfer capacity and product quality. In this work, the pressure drop was measured below and above minimum fluidization velocity (umf). Then, the axial and radial dispersion coefficients (DL and DR) were estimated below umf by measuring the step residence time distribution and the stationary radial tracer profiles, respectively. Pressure analysis show the agitation significantly reduces the bed pressure drop, changing the fixed bed below umf and bubbling bed above umf to an agitated bed with a periodic voidage. The DL was proportional to the gas velocity, with little influences of the stirring speed. The radial tracer profiles show the bed is divided by the inner diameter of the helical ribbon into the peripheral ascending region and the central descending region, without gas exchange between them. Furthermore. the tracer profiles in the descending region are classified into two types. For type I, the DR, calculated by the plug flow model with radial dispersion, is proportional to the gas velocity, with little effects of stirring speed. Type II shows uniform profiles due to the deflection of the gas flow toward the low pressure area at the inner diameter of helical ribbon. The causes of the two types are explained by the relative size of particle circulation and gas flux. These two flow regimes are quantitatively clarified with an empirical correlation of Re and Fr as flow regime transition boundary, namely dispersed plug flow and perfect mixing flow. With lower Re and higher Fr, it changes from dispersed plug flow to perfect mixing flow.

Polyethylene Particle Dynamics of Gas Phase Ethylene Polymerization in Fluidized Bed Reactor

Modeling of Molecular Weight and Copolymer Composition Distributions for Ethylene‐propylene Solution Copolymerization

Customization of Particle Size Distribution in Continuous Polymerization Process

Thermal stability analysis of ethylene polymerization fluidized bed reactors under condensed mode operation through a TPM-PBM integrated model

Important Mesoscale Phenomena in Gas Phase Fluidized Bed Ethylene Polymerization

Investigation of a Dynamic Operation Mode of Ethylene Polymerization Process with a Liquid-Containing Fluidized Bed

Physical Properties Computation of Pure Components for Ethylene Slurry Polymerization System

Stability Analysis Of Ethylene Polymerization In A Liquid-Containing Gas-Solid Fluidized Bed Reactor

Simulation of Particle Size Distribution in Gas Phase Ethylene Polymerization Fluidized-Bed Reactor

Mixing Effects on the Gas Flow and Mass Transfer in a Vertical Single Helical Ribbon Agitated Reactor for Propylene Polymerization

Stability and dynamic behaviors of gas-phase ethylene polymerization process under condensed mode operation

Control of Diffusion/Barrier Effects of Polymer-Coated Particles and the Strengthening of Ethylene Polymerization Reactor

Quality Predicting Models for Ethylene Terpolymerization to High-Performance Polyethylene

Minimum fluidization velocity of bimodal polyethylene particles

On-line Measurements and Model Analysis of Gas-phase Ethylene Polymerization Process in Fluidized Bed Reactor (II)

Computational Fluid Dynamics Simulation of Gas–liquid–solid Polyethylene Fluidized Bed Reactors Incorporating with a Dynamic Polymerization Kinetic Model

Collision Characterization of Mixed Hydrocarbon Liquid Droplets with Polyethylene Particles

A CFD-PBM Model Considering Ethylene Polymerization for the Flow Behaviors and Particle Size Distribution of Polyethylene in a Pilot-Plant Fluidized Bed Reactor

Liquid Containing Particle Polymerization: Ethylene/-Olefin Reaction in a New Environment

A Computational Fluid Dynamics Model Coupled with Ethylene Polymerization Kinetics for Fluidized Bed Polyethylene Reactor

Molecular Dynamics Simulation of in Situ Polymerization: Chain Conformation Transition