Abstract:This study investigates the effect of pressure on diffusion creep of dry San Carlos and synthetic (prepared by sol-gel method) olivine. We prepared dry (water content < 9 ppm wt) fine-grained (< 1 μm grain-size) olivine and deformed the samples (both San Carlos and solgel olivine in the same assembly) in the same sample assembly under high-pressure ( P = 2.9–8.8 GPa) and modest temperatures ( T = 980–1250 K) at a fixed strain-rate. Evolution of strength was studied using the radial X-ray diffraction from various diffraction planes. We found that San Carlos and sol-gel olivine show similar rheological behaviour (when normalized to the same grain-size). Stress estimated by the radial X-ray diffraction increases with time and initially shows similar values for all diffraction planes. In many cases, stress values start to depend on the diffraction planes in the later stage and time dependence becomes minor. The micro-structural observations show that grain-size increases during an experiment. The results are interpreted using a theory of radial X-ray diffraction and the theoretical models of diffusion and dislocation creep. We conclude that the initial stage of deformation is by diffusion creep, but deformation in the later stage is by dislocation creep. For dislocation creep, our results are in reasonable agreement with previous low temperature dislocation creep results after a correction of temperature effect. For diffusion creep, we obtain an activation volume of 7.0 ± 2.4 cm 3 /mol that is substantially smaller than the values reported on dislocation creep but agrees well with the results on grain-growth. By comparing the present results on dry olivine with the previous results on wet (water-saturated) olivine, we found that water enhances diffusion creep but only modestly in comparison to dislocation creep. The difference in the pressure and water content dependence between diffusion and dislocation creep has an important influence on the dominant deformation mechanisms of olivine in the upper mantle.

Experimental study of germanate olivine-spinel aggregates deformed in torsion

Experimental observation of dynamic recrystallization in olivine

Deformation of Olivine-Spinel Aggregates in the System (mg,ni)(2)geo4 Deformed to High Strain in Torsion: Implications for Upper Mantle Anisotropy

High strain torsion experiment on olivine aggregates.

Microstructural and Micromechanical Evolution of Olivine Aggregates During Transient Creep

Real Time Observation Experiment on Olivine Phase Transformation

High temperature deformation experiment on iron rich olivine.

Using Multigrain Crystallography to Explore the Microstructural Evolution of the α-Olivine to γ-Ringwoodite Transformation and ε-Mg2SiO4 at High Pressure and Temperature

High-Temperature Dislocation Creep In Ni2geo4 Spinel

Dynamic Recrystallization of Olivine During Simple Shear: Evolution of Microstructure and Crystallographic Preferred Orientation From Full‐Field Numerical Simulations

High‐Temperature Deformation of Enstatite‐Olivine Aggregates

In-situ Investigation Via High Energy X-ray Diffraction of Stress-Induced(0002)α→(110)β Transformation in a Ti-5.5Mo-7.2Al-4.5Zr-2.6Sn-2.1Cr Alloy

In Situ Observation of Texture Development in Olivine, Ringwoodite, Magnesiowüstite and Silicate Perovskite at High Pressure

Evolution of Microstructural Properties in Sheared Iron‐Rich Olivine

The Effect of Pressure on the Rheology of Olivine

Plastic deformation of dry fine-grained olivine aggregates under high pressures

On-chip very low strain rate rheology of amorphous olivine films

Plastic strain-induced olivine-ringwoodite phase transformation at room temperature: main rules and the mechanism of the deep-focus earthquake

The Effect of Physical and Chemical Environment on Rheological Behavior of Olivine Aggregates

Γ-Phase Transformation, Dynamic Recrystallization and Texture of a Forged TiAl-based Alloy Based on Plane Strain Compression at Elevated Temperature

Observations of grain size sensitive power law creep of olivine aggregates over a large range of lattice‐preferred orientation strength