Abstract:This study investigates the effect of pressure on diffusion creep of dry San Carlos and synthetic (prepared by sol-gel method) olivine. We prepared dry (water content < 9 ppm wt) fine-grained (< 1 μm grain-size) olivine and deformed the samples (both San Carlos and solgel olivine in the same assembly) in the same sample assembly under high-pressure ( P = 2.9–8.8 GPa) and modest temperatures ( T = 980–1250 K) at a fixed strain-rate. Evolution of strength was studied using the radial X-ray diffraction from various diffraction planes. We found that San Carlos and sol-gel olivine show similar rheological behaviour (when normalized to the same grain-size). Stress estimated by the radial X-ray diffraction increases with time and initially shows similar values for all diffraction planes. In many cases, stress values start to depend on the diffraction planes in the later stage and time dependence becomes minor. The micro-structural observations show that grain-size increases during an experiment. The results are interpreted using a theory of radial X-ray diffraction and the theoretical models of diffusion and dislocation creep. We conclude that the initial stage of deformation is by diffusion creep, but deformation in the later stage is by dislocation creep. For dislocation creep, our results are in reasonable agreement with previous low temperature dislocation creep results after a correction of temperature effect. For diffusion creep, we obtain an activation volume of 7.0 ± 2.4 cm 3 /mol that is substantially smaller than the values reported on dislocation creep but agrees well with the results on grain-growth. By comparing the present results on dry olivine with the previous results on wet (water-saturated) olivine, we found that water enhances diffusion creep but only modestly in comparison to dislocation creep. The difference in the pressure and water content dependence between diffusion and dislocation creep has an important influence on the dominant deformation mechanisms of olivine in the upper mantle.

Experimental observation of dynamic recrystallization in olivine

High strain torsion experiment on olivine aggregates.

Experimental study of germanate olivine-spinel aggregates deformed in torsion

Dynamic Recrystallization of Olivine During Simple Shear: Evolution of Microstructure and Crystallographic Preferred Orientation From Full‐Field Numerical Simulations

High temperature deformation experiment on iron rich olivine.

Skeletal morphologies and crystallographic orientations of olivine, diopside and plagioclase

Evolution of Microstructural Properties in Sheared Iron‐Rich Olivine

Real Time Observation Experiment on Olivine Phase Transformation

Microstructural and Micromechanical Evolution of Olivine Aggregates During Transient Creep

Experimental study of high temperature and high pressure rheology of fayalite

Deformation of Olivine-Spinel Aggregates in the System (mg,ni)(2)geo4 Deformed to High Strain in Torsion: Implications for Upper Mantle Anisotropy

Experimental investigation on water solubility in olivine single crystal with different fe content

Plastic deformation of dry fine-grained olivine aggregates under high pressures

The Effect of Pressure on the Rheology of Olivine

On-chip very low strain rate rheology of amorphous olivine films

High‐Temperature Deformation of Enstatite‐Olivine Aggregates

Re-configuration and Interaction of Hydrogen Sites in Olivine at High Temperature and High Pressure

In Situ Observation of Texture Development in Olivine, Ringwoodite, Magnesiowüstite and Silicate Perovskite at High Pressure

Effect of Iron Content on the Creep Behavior of Olivine: 1. Anhydrous Conditions

High-temperature and high-pressure Raman spectra of Fo89Fa11 and Fo58Fa42 olivines: Iron effect on thermodynamic properties

Protracted Fabric Evolution in Olivine: Implications for the Relationship among Strain, Crystallographic Fabric, and Seismic Anisotropy