High temperature deformation experiment on iron rich olivine.

Zhao YH,M Zimmerman,DL Kohlstedt
DOI: https://doi.org/10.3969/j.issn.1000-0569.2005.03.038
IF: 1.468
2005-01-01
Acta Petrologica Sinica
Abstract:Triaxial compressive creep experiments were performed on fine-grained Fe rich olivine samples of ( Mg-0.5 Fe-0.5)(2) SiO4 and (Mg0.7Fe0.1)(2)SiO4. Firstly, the fayalite, Fe2SiO4 powder was synthesized in one atmosphere furnace from high-purily oxides. Then, the (Mg-0.5,Mg- Fe-0.5)(2) SiO4 and ( Mg-0.7 Fe-0.3)(2) SiO4 samples were fabricated from a mixture of powders of San Carlos olivine, (Mg-0.9 Fe-0.1)(2) SiO4, and synthetic fayalite, Fe2SiO4. Samples were deformed in a gas-medium apparatus at a temperature of 1223 1473 K and a confining pressure of 300 MPa. Differential stresses in the range from 10 to 300 MPa resulted in strain rates between 10(-7) similar to 10(-4)s(-1). The samples were deformed both in diffusion creep and dislocation creep regimes. From the three dimensional global non-linear fitting of the test data, the stress exponent for Fo(50) and Fo(70) were determined as 4. 1 and 4. 3, respectively., and the activation energy for Fo(50) and Fo(70) as 499kJ/mol and 510kJ/mol, respectively. These Fo(50) samples creep at a rate over a factor of 10 faster than similar samples of Fo(70) and Fo(70) samples creep at a rate over a factor of 10 faster than those of Fo(90) deformed under the same conditions. Therefore, this paper gives a preliminary test result of effect of iron content on the viscosity of olivine aggregates.
What problem does this paper attempt to address?