Abstract:The absence of seismic anisotropy in most regions of the lower mantle suggests that diffusion creep may be the dominant mechanism in the lower mantle. Because the diffusion-creep rate is inversely proportional to the 2~3 power of grain size, knowledge of the grain-growth kinetics is crucial for studying lower-mantle dynamics. For these reasons, this study determined the grain-growth kinetics of bridgmanite at a pressure of 27 GPa using advanced multi-anvil techniques.We first measured the grain sizes of bridgmanite in an olivine bulk composition with various annealing durations at 2200 K. The results were fitted to an equation dn – d0n = kt, where d and d0 are the final and initial grain sizes, respectively, n is the grain-size exponent, t is the annealing duration, and k is the growth-rate constant. This fitting yielded n = 5.2 ± 0.3, which is much smaller than given by a previous study [Yamazaki et al., 1996], n = 10.6 ± 1.1. This discrepancy may be because Yamazaki et al.’s [1996] olivine starting material may have contained adhesive water, which enhanced grain growth at the beginning of annealing. We then conducted runs at various temperatures, yielding the activation energy of 260 ± 20 kJ/mol. These results suggest that the bridgmanite grain sizes over 0.1 – 1 Gyr should have grain sizes of 150-230 μm, which is one order of magnitude larger than Yamazaki et al.’s [2006] estimation. Consequently, the lower mantle should be much harder than previously considered.Furthermore, we measured the grain-growth kinetics as a function of the fraction of coexisting ferropericlase. Although the grain-growth kinetics is almost independent of the ferropericlase fraction down to 20 vol.%, it rapidly increases with decreasing ferropericlase fraction at lower fractions. Over 0.1~4.5 Gyr, the bridgmanite grain sizes in pure-bridgmanite rock should be 2 ~ 3 orders of magnitude larger than those coexisting with 20 vol.% of ferropericlase. These results suggest that pure-bridgmanite rock has 4 ~ 9 orders of magnitude lower flow rates than pyrolite if the diffusion creep is dominant. Since the diffusion creep rate in pure-bridgmanite rock is so low, the dislocation creep should dominate in pure-bridgmanite rock. We estimated that the pure-bridgmanite rock should have 1 ~ 2.5 orders of magnitude more viscous than pyrolite if the stress condition is 0.1~0.5 MPa in the lower mantle. This variation may interpret the viscosity variation in the lower mantle inferred from the geoid analysis [Rudolph et al., 2015], subduction speed [van der Meer et al., 2018], and plume morphology [French & Romaniwicz, 2016].

High-Temperature Dislocation Creep In Ni2geo4 Spinel

High-temperature creep in a Ni 2 GeO 4 : a contribution to creep systematics in spinel

New Constraints on Upper Mantle Creep Mechanism Inferred from Silicon Grain-Boundary Diffusion Rates

Dislocation Mobility in Ringwoodite As a Function of Temperature and Water Content

Deformation of Olivine-Spinel Aggregates in the System (mg,ni)(2)geo4 Deformed to High Strain in Torsion: Implications for Upper Mantle Anisotropy

Hydroxyl Defects and Oxide Vacancies Within Ringwoodite—toward Understanding the Defect Chemistry of Spinel-Type Oxides

High‐Temperature Deformation of Enstatite‐Olivine Aggregates

Grain Growth Kinetics of Bridgmanite under Topmost Lower-Mantle

Single-crystal Elasticity of Zn2TiO4-spinel Up to 18 GPa

Experimental study of germanate olivine-spinel aggregates deformed in torsion

Microstructural and Micromechanical Evolution of Olivine Aggregates During Transient Creep

Creep Behavior and Deformation Mechanism of a Third-Generation Single Crystal Ni-Based Superalloy at 980 °C

The Effect of Physical and Chemical Environment on Rheological Behavior of Olivine Aggregates

Effect of Iron Content on the Creep Behavior of Olivine: 1. Anhydrous Conditions

The Effect of Pressure on the Rheology of Olivine

High temperature deformation experiment on iron rich olivine.

Transient and steady-state dislocation creep of olivine controlled by dislocation interactions at the isostress endmember

Observations of grain size sensitive power law creep of olivine aggregates over a large range of lattice‐preferred orientation strength

Plastic deformation of dry fine-grained olivine aggregates under high pressures

In Situ SEM Study of Creep Deformation Behavior of Nickel-Based Single-Crystal Superalloys