Abstract:This article focuses on evaporative falling film heat transfer through numerical simulations. A two-dimensional symmetric liquid film flowing outside a single horizontal tube was simulated using the open-source CFD software OpenFOAM. The Tanasawa model was employed to consider mass transfer at the liquid–vapour interface, and the isoAdvector VOF method was used for interface tracking. The simulations explored the impact of film flow rate, tube surface heat flux, and tube diameter on the liquid film thickness and surface heat transfer coefficient. Additionally, the critical heat flux and operational limits were considered. The results demonstrate the accurate reproduction of evaporative falling film heat transfer performance by the present model. The film thickness exhibits a similar profile to adiabatic and sensible falling film heat transfer but provides smaller values. Similarly, the evaporative heat transfer coefficient exhibits significantly higher values and a gentle peripheral variation. The influence of heat flux on evaporative falling film heat transfer is contingent on the film flow rate; it can either enhance or weaken the process. Notably, a larger tube diameter negatively affects heat transfer, suppressing the impact of heat flux, and also increases the risk of liquid film dryout. For a given film flow rate, the average heat transfer coefficient increases initially, reaches a maximum value, and then decreases as the wall heat flux is increased. The peak heat flux, termed critical heat flux, increases with film flow rate but decreases with tube diameter. An operational limit exists where the heat flux is lower than the critical heat flux and the film flow rate is higher than the critical film flow rate; under these conditions, evaporative falling film heat transfer operates in a fully wetting status.

Study on Mathematical Model of Falling-Film Molecular Distillation Process

A Study on Flow and Heat Transfer Characteristics for Saturated Falling-Film Evaporation of Liquid Oxygen in a Vertical Channel

Numerical Analysis of Heat Transfer Characteristics of a Falling Film Type Plate-Fin Condenser/Reboiler

Numerical simulation of falling film evaporation of binary mixture

Establishment of the falling film evaporation model and correlation of the overall heat transfer coefficient

Thin liquid film flow and heat transfer under spray impingement

Mathematical model of two-phase flow processes in heat exchange tubes of the falling film evaporator

Model for Distribution of Heated Falling Liquid Film on Vertical Solid Planar Surface

Numerical Simulation On Heat Transfer Of Falling Film Flow Along A Vertical Wall

Study on the Temperature Distribution of Heated Falling Liquid Films

Boiling and evaporation model for liquid-gas flows: A sharp and conservative method based on the geometrical VOF approach

Investigation of Bubble Interaction in a Temporal and Spatial Heat Flux Partitioning Model for Subcooled Flow Boiling

Numerical simulation and modeling of the heat and mass transfer in a grooved flat falling film evaporator

Study on Shrinkage Characteristics of Heated Falling Liquid Films

Modelling of evaporative falling-film heat transfer over a horizontal tube

Computational study of falling film evaporation in vertical channel

Energy conservation principle and mathematic model of distillation with heat exchange inside

STUDY ON HEAT AND MASS TRANSFER OF AN AIR COOLED VERTICAL FALLING LIQUID FILM ABSORPTION

A Numerical Model for Simulating the Droplet Flow and Evaporation

Experimental study on the dryout heat flux of falling liquid film

Study on Temperature and Pressure Distribution and Flux of Vacuum Membrane Distillation