Study on Blends of Injection-Grade PPEK and PTFE

王桂梅,廖功雄,蹇锡高,洪升
DOI: https://doi.org/10.3321/j.issn:0253-4320.2004.04.009
2004-01-01
Abstract:The blends of injection-grade poly(phthalazinone ether ketone) (PPEK) and polytetrafluoroethylene (PTFE) less than 30%(mass ratio) were prepared by the injection moulding.The tribological and mechanical properties,thermal stability and density of the blends were studied.The results show that adding PTFE into PPEK can markedly improve the tribological properties of the blends,and the tribological properties could be enhanced with the increasing of the PTFE content.The mechanical properties of the blends decreased by adding PTFE into PPEK.Despite this decrease,the blends have good mechanical properties and potentially could still be used as high performance engineering plastics.The thermal properties of the blends varied little by adding PTFE,and the deforming temperatures are about 244℃.The density of the blends linearly increased with the increasing of the content of PTFE.
What problem does this paper attempt to address?