Abstract:Due to non-condensable gas under conditions of vacuum and low temperatures, it becomes difficult to obtain precise vapor pressures of typical liquid desiccants by an experiment. Usually, non-condensable gas is removed by a traditional degassing method (degassing after prepared solutions - DPS), in which prepared liquid desiccants are circularly frozen and non-condensable gas is pumped out. However, the solvent of liquid desiccants could greatly evaporate during traditional degassing processes. Concentrations of the prepared liquid desiccants could be greatly deviated from those of the prepared liquid desiccants. Accordingly, measured vapor pressures usually greatly deviate from those corresponding to the concentrations of the prepared liquid desiccants. Moreover, it becomes very difficult to determine new concentrations of the prepared liquid desiccants after degassing, precisely. To overcome the challenges for precise measurements of typical liquid desiccants, a novel technique is developed in this context. The new method is called DSSPS (degassing solvents and solutes before preparing solutions - DSSPS), in which degassed solvent and solute is weighted respectively, and then, is mixed as measured solutions. Thus, concentrations of the measured solutions could be determined easily and precisely. Vapor pressures of LiCl-H2O desiccants are measured by the new method at a range from 218K to 258K and with the mass fractions of solutions from 5% to 20%. Totally, 35 sets of vapor pressure are measured. Then, the data is correlated based on Antoine equation. The ARD% (Absolute Relative Deviation - ARD) of equation is from 0.04% to 3.21% and AARD% (Average Absolute Relative Deviation - AARD) is 1.73%. So, the new method could be used to measure vapor pressure of aqueous solutions at vacuum and low temperatures precisely. The average error between experimental data and the results calculated by EES (Engineering Equation Solver - EES) is within 15.2%, and its maximum error is 35.46%. Vapor pressure data in this context also provides important reference for development of a precise calculation model.

Determination of solid solubility in supercritical fluid by static equilibrium method

Determination of Solid Solubility in Supercritical Carbon Dioxide by Dynamic Method

An Apparatus for Determination of Mutual Solubilities in Near-critical Water

Correlation of Infinite-Dilution Diffusion Coefficients in Supercritical Fluids

Solubilities of Dodecylpolyoxyethylene Polyoxypropylene Ether in Supercritical Carbon Dioxide

Solubility of Troeger'S Base in Supercritical Carbon Dioxide

Solubility of titanocene dichloride in supercritical propane

Solubility of Oxymatrine in Supercritical Carbon Dioxide

SOLUBILITY MEASUREMENT OF POLYSTYRENE IN SUPERCRITICAL PROPANE

VAPOR PRESSURE MEASUREMNET OF LIQUID DESSICANTS AT LOW TEMPERATURES BY A NOVEL TECHNIQUE

Development and Verification of High Accuracy Apparatus for Solubility Measurement

Determination of water solubility in supercritical CO2 from 313.15 to 473.15 K and from 10 to 50 MPa by in-situ quantitative Raman spectroscopy

Solid-liquid equilibrium of in some pure solvents and binary solvents from 293.15 K to 318.15 K

Role of solvent properties and composition on the solid-liquid equilibrium of trifloxystrobin and thermodynamic analysis

Determination of Solubility and Nucleation Kinetics of Valnemulin Hydrochloride Solvate

Determination and analysis of flutamide solubility in different solvent systems at different temperatures (T = 278.15–323.15 K)

Determination And Modeling Of Solubility Of 4-Aminobenzamide In Different Pure Solvents

Extraction of Solanesol from Tobacco with Supercritical Carbon Dioxide

Fluid revisited: An overlook of a method for solubility measurements in supercritical fluids based on chromatography retention

Progress in Experimental Methods for Studying Phase Behavior of Supercritical Fluids System

Solubility in the Na2CO3 + NaHCO3 + Na2SO4 + NaCl + H2O System and Its Subsystems at 150 °C