Influence of Microstructure and Microelements on Corrosion Structure of Aluminum Foil

毛卫民,蒋恒,杨平,冯惠平,余永宁

DOI: https://doi.org/10.3321/j.issn:1004-0609.2004.10.001

2004-01-01

The Chinese Journal of Nonferrous Metals

Abstract:The surface corrosion structures of aluminum foils, which were annealed at 300 ℃ followed by rapid and slow cooling respectively, were observed after electrochemical etching. The distributions of microelements Fe, Si, Cu and Mg in the surface layer were also determined by secondary ioo mass spectrometer. It is found that the Mg content at external surface is increased exponentially over the four orders of magnitude in comparison with that in center layer. The corresponding contents of Fe and Si are increased about two orders of magnitude; while the content of Cu is increased lower than one order of magnitude. The slow cooling after annealing will lead to stronger segregation of microelements around the grain boundaries and dislocations in the surface, which aggravates the (inhomogeneity) of corrosion structure and results in low specific capacity.