Abstract:Hybrid electric vehicle (HEV) and plug-in hybrid electric vehicle (PHEV) require high power energy sources which are inexpensive and safe. Among various battery materials, 5V LiMn1.5Ni0.5O4 spinel materials are especially of interests for these vehicle applications because of their high operating voltage of ~4.7V and because manganese is inexpensive and less toxic than Ni and Co. However, the cycle life of these cathodes is inadequate and elevated temperature cycling cause rapid loss of capacity of the LiMn1.5Ni0.5O4 cells. This capacity degradation can be attributed to dissolution of Mn and Ni elements, solid electrolyte interphase (SEI) formation and electrolyte decomposition with high-voltage cycling [1]. Metal oxide coatings, which are usually synthesized by solution-based coating techniques, have improved capacity retention of the LiMn1.5Ni0.5O4 cells at the elevated temperatures and have been usually synthesized by solution-based coating techniques [2,3]. Recently, we have successfully coated nanometer thick amorphous lithium phosphorus oxyntirde (Lipon) electrolytes on the surfaces of LiMn1.5Ni0.5O4 and LiCoO2 particles by a RFmagnetron sputtering technique [4,5]. Uniform subnanometer thick Lipon improved the cycling behaviors of LiMn1.5Ni0.5O4 cells dramatically, but did not impede the Mn dissolution. Although a thicker Lipon layers of a few nanometers were effective in preventing the Mn dissolution, the Lipon layers greatly reduced the specific capacity because Lipon has a very low electronic conductivity of ~10 -14 S/cm. For comparison, nanometerthick protective films of electronic/ionic mixed conductor are being evaluated. Half-cell performances of cathodes fabricated with LiMn1.5Ni0.5O4 particles coated with mixed conductor will be reported for cycling at room and

Surface Modification Of Lico0.05mn1.95o4 Cathode By Coating With Sio2-Tio2 Composite

Surface Modification and Electrochemical Properties of Li-Rich Layered Cathode Materials for Lithium-Ion Batteries

Enhanced Electrochemical Performance of LiNi0.8Co0.15Al0.05O2 Cathode Material via Li2TiO3 Nanoparticles Coating

Enhanced Electrochemical Performance of Li1.2Mn0.54Ni0.13Co0.13O2 Cathode Material Coated with Li+-conductive Li2SiO3 for Lithium Ion Batteries

Improving rate capacity and cycling performance of lithium-rich high-Mn Li-1.8[Mn0.7Co0.15Ni0.15]O-2.675 cathode materials by Li2SiO3 coating

Research on LiNi_xMn_(2-x)O_4 Surface Modification of LiCoO_2 As Cathode Materials for Li-ion Batteries

Cycling Stability of 5V LiMn1.5Ni0.5O4 Spinel Particles Coated with a Thin Film Mixed Conductor

Structure and Electrochemical Performance of Modificated LiMn<sub>2</sub>O<sub>4</sub> by S-Co Codoping and Nano SiO<sub>2</sub> Surface Coating

Surface Modification Mechanism of Spinel Structure LiM_xMn_(2-x)O_4 As Cathode Materials for Lithium Ion Batteries

Structure and Electrochemical Performance of Modificated LiMn2O4 by S-Co Codoping and Nano SiO2 Surface Coating

Surface Modification and Characterization of LiNi_(0.8)Co_(0.2)O_2

Enhancing electrochemical performance of lithium-rich manganese-based cathode materials through lithium sulfate coating

Surface Coating with Li-Ti-O to Improve the Electrochemical Performance of Ni-rich Cathode Material

Effect of TiO 2 -Coating on Structure and Electrochemical Performance of LiCo 0.2 Ni 0.4 Mn 0.4 O 2

Enhancing Electrochemical Performance of LiNi0.6Co0.2Mn0.2O2 by Lithium-ion Conductor Surface Modification

Enhancing the electrochemical performances of LiNi 0.5 Mn 1.5 O 4 by Co 3 O 4 surface coating

Improved High Rate Capability of Li[Li0.2Mn0.534Co0.133Ni0.133]O2 Cathode Material by Surface Modification with Co3O4

Boosting the cycling performance of spinel LiMn2O4 by in situ MnBO3 coating

Ultrathin Li-Si-O Coating Layer to Stabilize the Surface Structure and Prolong the Cycling Life of Single-Crystal LiNi0.6Co0.2Mn0.2O2 Cathode Materials at 4.5 V

Binding Li 3 PO 4 to Spinel LiNi 0.5 Mn 1.5 O 4 via a Surface Co‐Containing Bridging Layer to Improve the Electrochemical Performance

Enhanced electrochemical performances of 5 v spinel LiMn 1.58Ni0.42O4 cathode materials by coating with LiAlO2