Abstract:The micro-electro-mechanical system (MEMS) resonator developed based on surface processing technology usually changes the section shape either due to excessive etching or insufficient etching. In this paper, a section parameter is proposed to describe the microbeam changes in the upper and lower sections. The effect of section change on the mechanical properties is studied analytically and verified through numerical and finite element solutions. A doubly-clamped microbeam-based resonator, which is actuated by an electrode on one side, is investigated. The higher-order model is derived without neglecting the effects of neutral plane stretching and electrostatic nonlinearity. Further, the Galerkin method and Newton⁻Cotes method are used to reduce the complexity and order of the derived model. First of all, the influence of microbeam shape and gap variation on the static pull-in are studied. Then, the dynamic analysis of the system is investigated. The method of multiple scales (MMS) is applied to determine the response of the system for small amplitude vibrations. The relationship between the microbeam shape and the frequency response is discussed. Results show that the change of section and gap distance can make the vibration soften, harden, and so on. Furthermore, when the amplitude of vibration is large, the frequency response softening effect is weakened by the MMS. If the nonlinearity shows hardening-type behavior at the beginning, with the increase of the amplitude, the frequency response will shift from hardening to softening behavior. The large amplitude in-well motions are studied to investigate the transitions between hardening and softening behaviors. Finally, the finite element analysis using COMSOL software (COMSOL Inc., Stockholm, Sweden) is carried out to verify the theoretical results, and the two results are very close to each other in the stable region.

Dynamic Characteristics Modeling and Analysis of a Torsional Micromirror

A study of dynamic characteristics and simulation of MEMS torsional micromirrors

A Study on the Coupled Dynamic Characteristics for a Torsional Micromirror

Nonlinear Characteristics Analysis of a DMD Micromirror

Macromodeling of the electrostatically actuated circular plate based on mode superposition method

Macromodeling Of The Electrostatically Actuated Rectangle Plate Based On Modal Projection

Theoretical modeling and experimental investigation of in-phase resonant MEMS mirrors with cascaded structures

Stability Analysis of Quasicrystal Torsion Micromirror Actuator Based on the Strain Gradient Theory

Electromagnetically Driven MEMS Micromirror with Torsion Beam Structure

Electromechanical Dynamics Analysis of Buckling Microstructure for Micromirror

Simulation, Optimization and Measurement of MEMS Torsion Micro Mirrors for Optical MEMS Application

Response Analysis of a 2D MEMS Electromagnetically Driven Micro-Mirror

Micro Torsion Mirror Actuated by Compound Electrostatic Driving Structure

Design, Fabrication and Characterization of Novel Micromirror with Vertical Torsion Comb Driver

Coupled Effects of Surface Interaction and Damping on Electromechanical Stability of Functionally Graded Nanotubes Reinforced Torsional Micromirror Actuator

Modeling and Simulation of Two-Dimensional MOEMS Scanning Mirror

Theoretical and finite element analysis of dynamic deformation in resonating micromirrors

Modeling Electrostatic MEMS Actuator

Electromechanical Studies On Micro Torsion-Mirror Actuators With Monolithically Integrated Fiber Self-Holding Structures

Distributed Microscopic Actuation Analysis of Deformable Plate Membrane Mirrors

Static and Dynamic Mechanical Behaviors of Electrostatic MEMS Resonator with Surface Processing Error