Abstract:Light mineral fillers are the natural inorganic materials of various compositions that have been used in a practical way since the beginning of the rubber industrial processing. Depending on the application, the natural kaolin is often modified by physical processes or by chemical processes (pillaring, adsorption, intercalation, functionalization, acid activation, etc.). It is important to modify kaolin due to improvement of its properties in order to adsorb the inorganic as well as organic molecules. In the introduced study, kaolin from Kaznějov deposit was modified by potassium acetate or dimethylsulphoxide and subsequently functionalized by accelerator dibenzothiazyldisulphide and its last modification was performed by silane treatment. Different techniques, such as the thermal (DTA) and spectral (FTIR) analysis were used to characterize modified kaolin samples. The main aim of the article is to observe the influence of modified kaolin forms on the physico-mechanical properties and structural changes of rubber mixtures. Combined with the carbon black, the given modified kaolin was mixed into a rubber blend in a particular ratio, which was5, 10, 24 phr. The effect of the modified kaolinite on the cure characteristics (minimum torque – M L, maximum torque – M H, optimal cure time – t 90, scorch time t s2) and mechanical properties (tensile strength at break – TS b, elongation at break – E b and hardness)in sulphur-cured rubber composites was investigated. In images from a scanning electron microscope (SEM), we observed the incorporation of modified forms of kaolin into the matrix of the rubber mixture.

Formulating of Recipe of Aramid Fiber Reinforced Rubber Sheet

Mechanical design of rubber-based sealing composites reinforced with short non-asbestos fibers

The Effect of Surface Pretreatment of Aramid Fiber on the Performance of Non-asbestos Sealing Material

Prescription Design and Optimization of Aramid and Pre-oxidized Fiber Reinforced Rubber-based Sealing Composite Material

Mechanical properties of aramid fiber reinforced rubber sealing gasket at different temperatures

Preparation of Reinforcement of Aramid Fiber and Fiberglass

Design of Non-asbestos Sealing Composite Material Based on Service Performances

Effect of graphite and its surface modification on thermal conductivity of silicone rubber

Effect of the Addition of Different Amounts of Aramid Fibers on Metal Friction and Wear during Mixing

Modification of the Filler based on Kaolin and its Use in the Polymer Composites

Application of Composite Powders Recycled from Graphite Tailings in Styrene-Butadiene Rubber

Research on the Mechanical and Thermal Properties of Carbon-Fiber-Reinforced Rubber Based on a Finite Element Simulation

In situ creation of aramid fiber surface coating with polymerizable deep eutectic solvents and their interfacial bonding properties with rubber

Study on the Abrasion of EPDM Rubblers

Study on the Assorted Non-Asbestos Fiber Reinforce Composite by Beater-Addition Process

Aramid fiber reinforced EPDM microcellular foams: Influence of the aramid fiber content on rheological behavior, mechanical properties, thermal properties, and cellular structure

The Effect of Surface Treatment Method to Heat Resistance of Aramid and Pre-oxidized Hybrid Fiber Reinforced Sealing Composite Material

Enhanced interfacial adhesion of aramid fiber reinforced rubber composites through bio‐inspired surface modification and aramid nanofiber coating

Fatigue Failure Behavior of Aramid Fiber Reinforced Styrene Butadiene Rubber Composite with Different Fiber Coatings

Study on mechanical properties and antifriction of calcium powder filled rubber

Fatigue and Creep Properties of Carbon Nanotube/Aramid Fiber Synergistically-Reinforced Rubber Sealing Composites