Abstract:Bearing plays an important role in industrial equipment and it may operate under varying conditions. When the speed of shaft changes, whether monotonous or non-monotonous speed, common diagnostic approaches cannot effectively extract fault features. But encoders and tachometers are not always available. Therefore, tacholess order tracking methods which can directly extract the instantaneous rotating frequency (IRF) from vibration signal are very useful in bearing fault diagnosis under varying speed. Among these methods, the generalized linear chirplet transform (GLCT) can produce time-frequency representation without constructing any mathematical model, but there are two parameters must be set in advance. The parameters have great influence on the analysis result. To reduce the dependence on the prior knowledge of presetting the parameters in varying conditions, two different improved GLCT methods are proposed in this paper. To do with the situation where the trend of speed changes is monotonous, the scale-space is introduced to lift GLCT which can adaptively set a vital parameter, and the other parameter is set to default value. When faced with non-monotonous speed, the second method is proposed which the grey wolf optimizer (GWO) and Gini index are introduced to search the optimal parameters of GLCT without any prior knowledge. With the help of the proposed methods, the IRF can be extracted directly from vibration signal. Then, the raw signal can be resampled based on the IRF to eliminate the influences of speed. The morphological filtering is adopted to remove the noise and extract the fault characteristics order (FCO). Another two typical time-frequency analysis methods are used for comparisons. Three different signals are used for analysis to demonstrate the superiority of the proposed methods.

Pseudo-Speed Tracking Order Analysis for Non-Stationary Vibration Signals of Rotating Machinery

A novel tacholess order tracking method for gearbox vibration signal based on extremums search of gearmesh harmonic

Study of Time-Frequency Order Tracking of Vibration Signals in Engine Speed Changing Stage

Bearing Fault Diagnosis under Non-Stationary Conditions Based on a Speed Signal Resonance Component Demodulation Algorithm

Parameterized Domain Mapping for Order Tracking of Rotating Machinery

The Application of Order Tracking for Vibration Analysis of a Varying Speed Rotor with a Propagating Transverse Crack

The HHT-based Analysis of Rotor Running Across Critical Rotating

The Error Caused by Order Analysis for Rolling Bearing Fault Signal

Research on an Estimate Method of Torsional Vibration for Rotating Machinery Based on HHT Analysis

Fault diagnosis of rotating machinery under time-varying speed based on order tracking and deep learning

Quantitative Detection of Vertical Track Irregularities under Non-Stationary Conditions with Variable Vehicle Speed

Adaptive tacholess order tracking method based on generalized linear chirplet transform and its application for bearing fault diagnosis

Dynamic time warping based instantaneous frequency estimation for rotating machineries under non-stationary operating conditions

A Computer-Vision-based Rotating Speed Estimation Method for Motor Bearing Fault Diagnosis

Study on Least-Square Adaptive Filter Order Tracking in Rotating Machinery

Envelope Deformation in Computed Order Tracking and Error in Order Analysis

Order tracking analysis using maximum likelihood estimator in the presence of crossing orders and low-resolution tacho signal

Current-Aided Dynamic Time Warping for Planetary Gearbox Fault Detection at Time-Varying Speeds

Research on the Online Measurement of Automobile Engine Speed Based on Vibration Analysis

An Expert System for the Diagnosis of Faults in Rotating Machinery Using Adaptive Order-Tracking Algorithm.

A tacholess order tracking method based on the STFTSC algorithm for rotor unbalance fault diagnosis under variable-speed conditions