Abstract:Mechanical fault diagnosis under varying speed conditions has gradually become an important issue in rotating machinery monitoring, especially the research on compound fault diagnosis is still rare. Order analysis is one of the most effective and widely used methods to eliminate the effects of speed fluctuations; however, it is difficult to extract compound fault features directly. Moreover, there are often many restrictions on the number and locations of sensors to be installed in practice, which also brings great challenges to compound fault diagnosis under varying speed conditions. In this article, a novel compound fault detection method with virtual multichannel signals in the angle domain is proposed to solve these problems for rolling bearing monitoring under varying speed conditions. First, we aim to use only a vibration acceleration sensor and a noncontact rotational speed sensor to adapt to limitations on sensor installation in practical applications. However, this may result in an underdetermined problem when trying to detect a compound fault with only a single-channel vibration signal. Then we make it up through constructing virtual multichannel signals based on variational mode decomposition theory, before which the nonstationary vibration signal is converted from the time domain into a stationary signal in the angle domain with computed order tracking to eliminate speed fluctuations. Finally, these virtual signals can be easily taken as input to a normal independent component analysis, and different faults can be detected in the order spectrum of each independent component. Case studies on rolling bearing experiments verified the advantages of the proposed method in compound fault detection under varying speed conditions.

The Error Caused by Order Analysis for Rolling Bearing Fault Signal

Envelope Deformation in Computed Order Tracking and Error in Order Analysis

EOF Analysis of Vibration Signal in the Diagnosis of Rolling Bearings

Bearing Fault Diagnosis under Non-Stationary Conditions Based on a Speed Signal Resonance Component Demodulation Algorithm

Research of Singular Value Decomposition Based on Slip Matrix for Rolling Bearing Fault Diagnosis

A New Angular Resampling Algorithm for the Bearing Fault Diagnosis under the Time-Varying Rotational Speed

Fault Diagnosis of Rolling Bearing Based on Wavelet Packet and Fourier Analysis

Time-Varying Demodulation Analysis for Rolling Bearing Fault Diagnosis under Variable Speed Conditions

Compound Bearing Fault Detection Under Varying Speed Conditions With Virtual Multichannel Signals in Angle Domain

Fault Diagnosis of Bearing under Varying Speed Using Hilbert Computed Order Spectrum and Ensemble of Auto-Encoders

Bearing Fault Diagnosis under Time-Varying Speed and Load Conditions Via Speed Sensorless Algorithm and Angular Resample

Fault Feature Extraction and Enhancement of Rolling Element Bearing in Varying Speed Condition

Rolling Element Bearing Fault Diagnosis Via Fault Characteristic Order (FCO) Analysis

Fault diagnosis of rolling bearing under a variable rotational speed and gear vibration noise based on revised ANC algorithm and FCO spectrum

Nonlinear vibration signatures for localized fault of rolling element bearing in rotor-bearing-casing system

Rolling Bearing Weak Fault Feature Extraction under Variable Speed Conditions via Joint Sparsity and Low-Rankness in the Cyclic Order-Frequency Domain

Bearing fault diagnosis under unknown variable speed via gear noise cancellation and rotational order sideband identification

Two-Step Adaptive Chirp Mode Decomposition for Time-Varying Bearing Fault Diagnosis

A time-varying instantaneous frequency fault features extraction method of rolling bearing under variable speed

Vibration Health Monitoring of Rolling Bearings under Variable Speed Conditions by Novel Demodulation Technique

A Novel Method for Bearing Fault Diagnosis under Variable Speed Based on Envelope Spectrum Fault Characteristic Frequency Band Identification