Fault diagnosis of rolling bearing under a variable rotational speed and gear vibration noise based on revised ANC algorithm and FCO spectrum

Tian-yang WANG,Jian-yong LI,Wei-dong CHENG
DOI: https://doi.org/10.13465/j.cnki.jvs.2014.18.002
2014-01-01
Abstract:There are two main obstacles of rolling bearing diagnosis,they are variable rotational speed and gear vibration noise.Although they can be partly overcome with order tracking based on rotational speed information from a tachometer and ANC algorithm using a reference sensor,the rotational speed information and the reference signal are not easy to get in real engineering due to design or cost reasons.To solve this problem,a new algorithm with five main steps was proposed here.These steps were that (a)a revised ANC algorithm using a newly constructed reference signal based on instantaneous dominant meshing harmonics (IDMH)trend is used to weaken the interferences from gear vibration noise;(b )a fast algorithm of spectral kurtosis (SK)method is used to determine the central frequency,the filtering frequency band and the corresponding scale of the high-frequency resonances induced by bearing faults to get a filtering envelope reflecting bearing faults clearly;(c )the envelop time-frequency speetrum after two-filtering is gained and the instantaneous fault characteristic frequency (IFCF)is extracted using the peak-searching algorithm;(d)a new resampling algorithm based on sampling rate resetting is proposed and the filtered results of SK are resampled in fault order field;(e) the fault characteristic order (FCO)spectrum of the resampled signal is obtained using FFT,a new fault diagnosis strategy is proposed to judge the operating states of a rolling bearing.The effectiveness of the proposed method was validated with both simulated and experimental faulty bearing vibration signals.
What problem does this paper attempt to address?