Abstract:An experimental study of particulate matter emissions was conducted on a Direct Injection Gasoline (DIG) engine produced by a Chinese Original Equipment Manufacturer (OEM) to investigate the impacts of fuel properties from China market on particulate emissions of modern gasoline vehicles. The emissions include both the primary emissions and the secondary ones in the atmosphere. The objective of this work is to provide some experimental data and analysis on the impacts of fuel properties and vehicle technologies on Particulate Matter 2.5 (PM2.5) in China. On the basis of better understanding of those impacts, it is desired to provide some suggestions and guidelines on how to improve fuel quality and vehicle technology to help effectively reduce air pollution in China.In this paper, six test fuels with different aromatics, olefin, sulfur, Methyl-cyclopentadienyl Manganese Tricarbonyl (MMT), ethanol content were blended and tested to research on the influences on primary particulate emission including mass, number, size distribution and compounds including Polycyclic Aromatic Hydrocarbons (PAHs) and the toxicity of PAHs emissions. The test results demonstrated that the fuel compositions impacted significantly on particulate emissions of DIG engine. Higher aromatics in gasoline resulted in much higher Particle Mass (PM), Particle Number (PN) and PAHs emission and much higher toxicity to human health. Reducing olefin content in gasoline showed benefits to a certain degree on reducing PM and PN emission especially under high load engine operation conditions, and did not show obvious improvement of PAHs emission factor, but reduced the toxicity of PAHs. 10% of Ethanol in gasoline showed limited improvement on particulate emissions comparing with the effect of reducing aromatics and olefin content in gasoline, moreover E10 increased PN emission under low load conditions. The test results also demonstrated that the typical China Phase V gasoline did not show benefits of reducing vehicle emissions the typical Phase IV gasoline with higher sulfur (<=50 ppm) and manganese (<=8 mg Mn/l) in China market.The particulate compounds of DIG engine mainly consisted Elemental Carbon (EC), Organic Matter (OM) and small amount of inorganic ions. The mass percentage of EC in total PM increased as the load of engine rose. Three-way Catalyst (TWC) is more effective in reducing OM than EC, with the overall OM reduction rate of 67-85%. (C) 2015 Elsevier Ltd. All rights reserved.

Study of the Timing on Characteristics of Particulate Emissions for LPG and Gasoline Fuels

Study on injection characteristics of diesel and DME

Numerical Investigations of Injection Timing Effects on a GDI Engine Performance: Part B, In-Cylinder Emission Formation and Oxidation Process

Individual particles emitted from gasoline engines: Impact of engine types, engine loads and fuel components

An Experimental Research on the NOx Emissions of the 492Q Gasoline Engine Using LPG

An Analysis on the Microstructure and Oxidation Characteristics of Particles from Diesel Engine in Exhaust Gas Transport Process

The Impact of Fuel Compositions on the Particulate Emissions of Direct Injection Gasoline Engine

Experimental Study on Intake Liquid Injection of LPG-Fueled Engine

Effect of gasoline aromatic compositions coupled with single and double injection strategy on GDI engine combustion and emissions

Numerical Investigation of the Effect of Injection Timing on the In-Cylinder Activity of a Gasoline Direct Injection Engine

Experimental study on particle size distribution of gasoline compression ignition (GCI) at low-load condition

Physicochemical Analysis of Particle Matter from a Gasoline Direct Injection Engine Based on the China Light-Duty Vehicle Test Cycle

Investigation of Adsorption Characteristics and Influencing Factors for Diesel Engine Exhaust Particles

Effect of Injection Strategy on Emission Characteristics of Compression Ignition Engine Fueled with Blended Fuel

The Study of Motorcycle Engine based on Electronic Controlled Liquefied Petroleum Gas Injection

Effect Of Injection Timing On Gasoline Homogeneous Charge Compression Ignition Particulate Emissions

Physical and Chemical Characteristics of PM2.5 Emissions from Gasoline Direct Injection Engine and Its Influence Factors

[Number Concentration and Size Distribution of Particles Emitted by Light-duty Gasoline Vehicles].

Characterizing the particle number emissions of light-duty gasoline vehicles under different engine technologies and driving conditions

Effects of the lubricating oil and diesel mixture combustion on the oxidation and microphysical properties of particulate matter

An Experimental Study on Particle Evolution in the Exhaust Gas of a Direct Injection SI Engine