Abstract:In this work, a detailed study on the number of exhaust particles, the particle size distribution and the geometric mean diameter from a 1.5 l gasoline direct-injection engine running with different engine operating parameters was conducted. The air-to-fuel ratio, the spark timing, the injection timing and the exhaust gas recirculation rate were varied at the same engine speed and the same engine load in order to understand how the mixture condition before ignition and the oxygen concentration affect the particulate matter emissions in terms of the total number and the size distribution. The experimental results showed that a lean mixture can significantly reduce the total number of particles by up to 90% compared with the rich mixture condition. When a lean mixture was used, most of the particulate matter was in the nucleation mode. The higher air-to-fuel ratio may have enhanced the oxidation of particles in the combustion process. Delaying the spark timing can also reduce the particulate matter emissions, especially for nucleation-mode particles which decreased by up to 65.41% compared with those for the early-spark-timing condition. The lower in-cylinder temperature may have resulted in the formation of a reduced number of nucleation-mode particles. The injection timing affected both the mixing process and the heat release process and could be optimized to reduce the particulate matter emissions. For a brake mean effective pressure of 3 bar, advanced injection timing reduced the numbers of particles in both the nucleation mode and the accumulation mode. The longer mixing duration improved the mixture homogeneity and led to lower formation rates of particles. Increasing the exhaust gas recirculation rate was effective in reducing the accumulation-mode particle emissions, while increasing the nucleation-mode particle emissions.

Physical and Chemical Characteristics of PM2.5 Emissions from Gasoline Direct Injection Engine and Its Influence Factors

An Experimental Study on Particle Number, Micromorphology and Nanostructure Characteristics of Particulate Matter from a China Ⅵ Gasoline Direct Injection Engine

Physicochemical Analysis of Particle Matter from a Gasoline Direct Injection Engine Based on the China Light-Duty Vehicle Test Cycle

Impact of Test Cycle on Mass, Number and Particle Size Distribution of Particulates Emitted from Gasoline Direct Injection Vehicles

Impact of Fuel and Injection System on Particle Emissions from A Gdi Engine

Numerical Investigations of Injection Timing Effects on a GDI Engine Performance: Part B, In-Cylinder Emission Formation and Oxidation Process

Individual particles emitted from gasoline engines: Impact of engine types, engine loads and fuel components

Effect of Working Condition, Particle Size and Oxidation Temperature on Micromorphology and Nanostructure of Particulate Matter from China Vi Gdi Engine

Investigation of the combustion and particle emission characteristics of a GDI engine with a 50 MPa injection system

Gasoline direct injection vehicles exceed port fuel injection ones in both primary aerosol emission and secondary aerosol formation

Experimental Study on the Particulate Matter Emission Characteristics for A Direct-Injection Gasoline Engine

Effect of Oil Consumption on Particulate Emissions of GDI Engine

Numerical Investigation of the Effect of Injection Timing on the In-Cylinder Activity of a Gasoline Direct Injection Engine

Effect of Working Conditions on Oxidation Activity and Surface Functional Group of Particulate Matter Emitted from China Ⅵ GDI Engine

An experimental study of polycyclic aromatic hydrocarbons and soot emissions from a GDI engine fueled with commercial gasoline

Particle Number and Size Distributions from Gasoline Engine

Effect of Starting Idling Condition and Mixture Concentration of a Turbocharged GDI Engine on Particle Emission

Size Distribution, Chemical Composition and Oxidation Reactivity of Particulate Matter from Gasoline Direct Injection (GDI) Engine Fueled with Ethanol-Gasoline Fuel

Particulate Emissions from Gasoline Vehicles Using Three Different Fuel Injection Technologies

Particulate Emissions from Gasoline Direct Injection Engines: A Review of How Current Emission Regulations Are Being Met by Automobile Manufacturers.

Particulate number and size distribution of dimethyl ether/gasoline combined injection spark ignition engines at medium engine speed and load