Abstract:An experimental study of particulate matter emissions was conducted on a Direct Injection Gasoline (DIG) engine produced by a Chinese Original Equipment Manufacturer (OEM) to investigate the impacts of fuel properties from China market on particulate emissions of modern gasoline vehicles. The emissions include both the primary emissions and the secondary ones in the atmosphere. The objective of this work is to provide some experimental data and analysis on the impacts of fuel properties and vehicle technologies on Particulate Matter 2.5 (PM2.5) in China. On the basis of better understanding of those impacts, it is desired to provide some suggestions and guidelines on how to improve fuel quality and vehicle technology to help effectively reduce air pollution in China.In this paper, six test fuels with different aromatics, olefin, sulfur, Methyl-cyclopentadienyl Manganese Tricarbonyl (MMT), ethanol content were blended and tested to research on the influences on primary particulate emission including mass, number, size distribution and compounds including Polycyclic Aromatic Hydrocarbons (PAHs) and the toxicity of PAHs emissions. The test results demonstrated that the fuel compositions impacted significantly on particulate emissions of DIG engine. Higher aromatics in gasoline resulted in much higher Particle Mass (PM), Particle Number (PN) and PAHs emission and much higher toxicity to human health. Reducing olefin content in gasoline showed benefits to a certain degree on reducing PM and PN emission especially under high load engine operation conditions, and did not show obvious improvement of PAHs emission factor, but reduced the toxicity of PAHs. 10% of Ethanol in gasoline showed limited improvement on particulate emissions comparing with the effect of reducing aromatics and olefin content in gasoline, moreover E10 increased PN emission under low load conditions. The test results also demonstrated that the typical China Phase V gasoline did not show benefits of reducing vehicle emissions the typical Phase IV gasoline with higher sulfur (<=50 ppm) and manganese (<=8 mg Mn/l) in China market.The particulate compounds of DIG engine mainly consisted Elemental Carbon (EC), Organic Matter (OM) and small amount of inorganic ions. The mass percentage of EC in total PM increased as the load of engine rose. Three-way Catalyst (TWC) is more effective in reducing OM than EC, with the overall OM reduction rate of 67-85%. (C) 2015 Elsevier Ltd. All rights reserved.

Physicochemical Analysis of Particle Matter from a Gasoline Direct Injection Engine Based on the China Light-Duty Vehicle Test Cycle

Impact of Test Cycle on Mass, Number and Particle Size Distribution of Particulates Emitted from Gasoline Direct Injection Vehicles

An experimental study of polycyclic aromatic hydrocarbons and soot emissions from a GDI engine fueled with commercial gasoline

An Experimental Study on Particle Number, Micromorphology and Nanostructure Characteristics of Particulate Matter from a China Ⅵ Gasoline Direct Injection Engine

The Impact of Fuel Compositions on the Particulate Emissions of Direct Injection Gasoline Engine

Individual particles emitted from gasoline engines: Impact of engine types, engine loads and fuel components

An Analysis on the Microstructure and Oxidation Characteristics of Particles from Diesel Engine in Exhaust Gas Transport Process

Morphology and Size of the Particles Emitted from a Gasoline-Direct-injection-engine Vehicle and Their Ageing in an Environmental Chamber

Physical and Chemical Characteristics of PM2.5 Emissions from Gasoline Direct Injection Engine and Its Influence Factors

The research progress of particulate emissions from vehicles with gasoline direct injection engines

Variation of Particles in the Exhaust Plume of Gasoline Direct Injection Vehicles Based on a Multipoint Sampling System: Concentrations, Components, and Numbers

Effect of Working Conditions on Oxidation Activity and Surface Functional Group of Particulate Matter Emitted from China Ⅵ GDI Engine

Effect of Working Condition, Particle Size and Oxidation Temperature on Micromorphology and Nanostructure of Particulate Matter from China Vi Gdi Engine

Morphology and composition of particles emitted from a port fuel injection gasoline vehicle under real-world driving test cycles

Recent Progress in Particle Matter Emissions and Control Strategies of Gasoline Direct Injection Engines

Analysis of Particulate Matter Composition from a Heavy-Duty Diesel Engine

Effect of Oxidation Temperature on Oxidation Reactivity and Nanostructure of Particulate Matter from a China VI GDI Vehicle

FTIR and SEM/EDS Analyses of the Deposits from a Gasoline Direct Injection Engine

Characterization of Particles from a Current Technology Heavy-Duty Diesel Engine

Particle Number and Size Distributions from Gasoline Engine

Chemical Characteristics of Particulate Matter Emission from a Heavy-Duty Diesel Engine Using ETC Cycle Dynamometer Test