Abstract:An experimental study of particulate matter emissions was conducted on a Direct Injection Gasoline (DIG) engine produced by a Chinese Original Equipment Manufacturer (OEM) to investigate the impacts of fuel properties from China market on particulate emissions of modern gasoline vehicles. The emissions include both the primary emissions and the secondary ones in the atmosphere. The objective of this work is to provide some experimental data and analysis on the impacts of fuel properties and vehicle technologies on Particulate Matter 2.5 (PM2.5) in China. On the basis of better understanding of those impacts, it is desired to provide some suggestions and guidelines on how to improve fuel quality and vehicle technology to help effectively reduce air pollution in China.In this paper, six test fuels with different aromatics, olefin, sulfur, Methyl-cyclopentadienyl Manganese Tricarbonyl (MMT), ethanol content were blended and tested to research on the influences on primary particulate emission including mass, number, size distribution and compounds including Polycyclic Aromatic Hydrocarbons (PAHs) and the toxicity of PAHs emissions. The test results demonstrated that the fuel compositions impacted significantly on particulate emissions of DIG engine. Higher aromatics in gasoline resulted in much higher Particle Mass (PM), Particle Number (PN) and PAHs emission and much higher toxicity to human health. Reducing olefin content in gasoline showed benefits to a certain degree on reducing PM and PN emission especially under high load engine operation conditions, and did not show obvious improvement of PAHs emission factor, but reduced the toxicity of PAHs. 10% of Ethanol in gasoline showed limited improvement on particulate emissions comparing with the effect of reducing aromatics and olefin content in gasoline, moreover E10 increased PN emission under low load conditions. The test results also demonstrated that the typical China Phase V gasoline did not show benefits of reducing vehicle emissions the typical Phase IV gasoline with higher sulfur (<=50 ppm) and manganese (<=8 mg Mn/l) in China market.The particulate compounds of DIG engine mainly consisted Elemental Carbon (EC), Organic Matter (OM) and small amount of inorganic ions. The mass percentage of EC in total PM increased as the load of engine rose. Three-way Catalyst (TWC) is more effective in reducing OM than EC, with the overall OM reduction rate of 67-85%. (C) 2015 Elsevier Ltd. All rights reserved.

FTIR and SEM/EDS Analyses of the Deposits from a Gasoline Direct Injection Engine

Physicochemical Analysis of Particle Matter from a Gasoline Direct Injection Engine Based on the China Light-Duty Vehicle Test Cycle

The Effects of Deposits on Spray Behaviors of a Gasoline Direct Injector

Effect of Fuel Injector Deposit on Spray Characteristics, Gaseous Emissions and Particulate Matter in a Gasoline Direct Injection Engine

Effects of GDI Injector Deposits on Spray and Combustion Characteristics under Different Injection Conditions

Impact of Injector Tip Deposits on Gasoline Direct Injection Engine Combustion, Fuel Economy and Emissions

Exploring the formation mechanisms of internal diesel injector deposits: A laboratory study

Individual particles emitted from gasoline engines: Impact of engine types, engine loads and fuel components

The Effects of Surface Temperature on the Deposit Behaviors of Gasoline on a Hot Surface

Analytical study on deposits of the aircraft engine piston

University of Birmingham Effect of fuel injector deposit on spray characteristics, gaseous emissions and particulate matter in a gasoline direct injection engine

Assessment of Gasoline Direct Injector Fouling Effects on Fuel Injection, Engine Performance and Emissions

The Impact of Fuel Compositions on the Particulate Emissions of Direct Injection Gasoline Engine

A Review of Experimental Studies on Deposits in the Combustion Chambers of Internal Combustion Engines

Numerical Investigations of Injection Timing Effects on a GDI Engine Performance: Part B, In-Cylinder Emission Formation and Oxidation Process

Impact of Gasoline Engine Deposits on Light Duty Vehicle Emissions: In-Use Case Study in Beijing, China

Improved HRTEM Image Processing Methods and the Application on Soot Nanostructure Analysis for GDI Engine

Morphology and composition of particles emitted from a port fuel injection gasoline vehicle under real-world driving test cycles

Fuel Injector Deposits in Direct-Injection Spark-Ignition Engines

Impact of Lubricating Oil Combustion on Nanostructure, Composition and Graphitization of Diesel Particles

Investigation of Injector Coking Effects on Spray Characteristic and Engine Performance in Gasoline Direct Injection Engines